Fujitsu SPARC Enterprise T5440 Server Podręcznik dla początkujących - Strona 2
Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla Serwer Fujitsu SPARC Enterprise T5440 Server. Fujitsu SPARC Enterprise T5440 Server 8 stron.
Również dla Fujitsu SPARC Enterprise T5440 Server: Podręcznik przeglądowy (26 strony), Podręcznik planowania witryny (24 strony)
Drukuj stronę
1. Unpack the server, and check that you received all of the shipping contents.
2. Place the server in its intended location for verification.
For rackmounting instructions, refer to the instructions included with the rail kit, the service label on the server, and to the
online SPARC Enterprise T5440 Server Installation and Setup Guide.
3. Connect a serial cable between the server's SER MGT port (
This connection provides your initial communication with the service processor (SP).
The terminal device can be a terminal, a terminal server, or a laptop with terminal emulation software running. The device must
be set up to communicate using 9600 baud, 8 bit, no parity, 1 stop bit. A null modem configuration is needed, meaning the
transmit and receive signals are reversed (crossed over) for DTE to DTE communications. You can use the supplied RJ-45
crossover adapters with a standard RJ-45 cable to achieve the null modem configuration.
Server Connections
FIGURE 2
n
Numbered cables
correspond to setup steps.
4. (Optional) Connect an Ethernet cable between the server's Net MGT port (
connections to the SP and host will be made.
After the initial configuration of the system using the SP SER MGT port, communication with the SP and host is usually
performed through this Ethernet interface.
5. Connect an Ethernet cable between one of the server's NET ports (
communicate.
6. Plug the power cords into the power supplies and into a power source.
Note - Only two power connections are required for operation. Use four power connections and two circuits for redundancy.
When power is applied, the SP initializes and power supply LEDs illuminate. After a few minutes, the SP login prompt appears
on the terminal device. The host is not initialized or powered on at this time.
) and a terminal device.
FIGURE 2
SER MGT
NET MGT
NET 0 to NET 3
RJ-45
RJ-45
RJ-45 to DB-25
RJ-45 to DB-9
) and the network to which future
FIGURE 2
) and the network to which the server will
FIGURE 2
RJ-45
Host to Ethernet
SP to Ethernet
(Optional)
crossover
adapter
crossover
adapter
Terminal
device