Fujitsu SPARC Enterprise T5440 Server Podręcznik dla początkujących - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla Serwer Fujitsu SPARC Enterprise T5440 Server. Fujitsu SPARC Enterprise T5440 Server 8 stron.
Również dla Fujitsu SPARC Enterprise T5440 Server: Podręcznik przeglądowy (26 strony), Podręcznik planowania witryny (24 strony)
Drukuj stronę
7. At the terminal device, log in to the SP as root with the password changeme.
SUNSP00144FAC732F login: root
Password: changeme
. . .
->
After a brief delay, the SP prompt is displayed (->). At this point, there are many commands you can perform using the
Integrated Lights Out Manager interface.
Additional SP information, such as how to change the password and how to set up the SP network parameters is available in the
online documentation set.
8. Power on the server and redirect the host output to display on the serial terminal device:
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
-> start /SP/console
Are you sure you want to start /SP/CONSOLE (y/n)? y
Serial console started. To stop, type #.
. . .
After you start the SP console, the server initialization takes approximately 20 minutes to complete.
9. When prompted, follow the onscreen instructions and enter the following configuration information.
You will be prompted to confirm the configuration several times, enabling confirmation and changes. If you are not sure how to
respond to a particular value, you can accept the default, and make future changes when the Solaris OS is running.
Parameter
Language
Locale
Terminal Type
Network?
Multiple Network Interfaces
DHCP?
Host Name
IP Address
Subnet?
Subnet Netmask
IPv6?
Security Policy
Confirm
Name Service
NFSv4 Domain Name
Time Zone (Continent)
Time Zone (Country or Region)
Time Zone
Date and Time
root Password
When the configuration menus are completed, the server reboots and displays the Solaris login prompt.
Description
Select a number from the displayed language list.
Select a number from the displayed locale list.
Select a terminal type that corresponds with your terminal device.
Select Yes.
Select the network interfaces that you plan to configure. If you are not sure, select the first one in the
list.
Select Yes or No according to your network environment.
Enter the host name for the server.
Enter the IP address for this Ethernet interface.
Select Yes or No according to your network environment.
(If subnet was Yes) Enter the netmask for the subnet for your network environment.
Specify whether or not to use IPv6. If you are not sure, select No to configure the Ethernet interface
for IPv4.
Select either standard UNIX
Review the onscreen information and change it if needed. Otherwise, continue.
Select the name service according to your network environment.
Note–If you select a name service other than None, you will be prompted for additional name service
configuration information.
Select the type of domain name configuration according to your environment. If you are not sure,
select Use the NFSv4 domain derived by the system.
Select your continent.
Select your country or region.
Select the time zone.
Accept the default date and time or change the values.
Enter the root password twice. This password is for the superuser account for the Solaris OS on this
server. This password is not the SP password.
®
security (No) or Kerberos Security (Yes). If you are not sure, select No.