Fujitsu ScanSnap S300 Podręcznik dla początkujących - Strona 31
Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla Skaner Fujitsu ScanSnap S300. Fujitsu ScanSnap S300 37 stron. Color image scanner
Również dla Fujitsu ScanSnap S300: Procedury instalacji (3 strony), Specyfikacja (2 strony), Instrukcje czyszczenia (2 strony)
Drukuj stronę
Symptom
Scanning
Does the
does not
continuously?
start.
Did you resume the computer
from the hibernation state?
Is ScanSnap Manager started?
(If ScanSnap Manager is
started up successfully, the
[ScanSnap Manager] icon
appears on the task bar.)
Is ScanSnap Manager running
properly?
(If ScanSnap Manager is not
running properly, the
[ScanSnap Manager] icon in the
task bar is displayed as
The scanner
Did you connect the scanner to
is not
your PC before installing
recognized
ScanSnap Manager?
even if
Is the scanner registered as
ScanSnap
"Other Device" or "Unknown
Manager is
Device" in the "Device
installed.
Manager"?
Check This Item
LED light blink
S
S
Disconnect the power or USB bus power
cable and connect it again.
(Note: Wait at least 5 seconds before
reconnecting the power or USB bus power
cable.)
When you perform scanning after resuming
the computer from the hibernation state,
move the mouse or press any key before
scanning.
If the [ScanSnap Manager] icon is not
displayed, select [Start]
[ScanSnap Manager]
to start ScanSnap Manager.
S
Do the following:
1.Update ScanSnap Manager driver.
On the [Start] menu, select [Control
panel]
[System]
[Device Manager].
In the [Device Manager], right-click
.)
[ScanSnap S300] and select [Update
Driver] from the menus displayed. If this
does not improve the situation, perform
step 2.
2.Turn the ScanSnap OFF and ON again. If
this does not improve the situation,
perform step 3. (Note: Wait at least 5
seconds before turning the scanner on.)
3.If a USB hub is used, directly connect the
ScanSnap to your PC. If this does not
improve the situation, perform step 4.
4.Restart your PC.
If none of the above operations resolve the
problem, uninstall and re-install ScanSnap
Manager.
For how to uninstall ScanSnap Manager,
refer to "Appendix B Uninstalling
ScanSnap" in "ScanSnap S300
Operator's Guide."
On the [Start] menu, select [Control panel]
[System]
Manager]. Delete the device name such as
USB device (differs with the OS) under
"Other Device" selection in the [Device
Manager] and restart your PC.
ScanSnap S300 Getting Started
Remedy
[All Programs]
[ScanSnap Manager]
[Hardware]
[Hardware]
[Device
30