Brother Quattro 6000D Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Oprogramowanie Brother Quattro 6000D. Brother Quattro 6000D 29 stron. Kit de actualización iii
Również dla Brother Quattro 6000D: Podręcznik (42 strony), Instrukcja obsługi (50 strony), Instrukcja obsługi (6 strony), Podręcznik użytkownika (48 strony), Instrukcja obsługi (21 strony), (Angielski) Instrukcja obsługi (49 strony), (Angielski) Instrukcja obsługi (21 strony), (Angielski) Instrukcja obsługi (48 strony)

Drukuj stronę
Brother Quattro 6000D Instrukcja obsługi
Note
• The bobbin case (gray) cannot be used for sewing in
any way other than bobbin work. After sewing
bobbin work, refer back to the steps in "Preparing
the Bobbin Thread" on page 6 for removing and
cleaning the bobbin case (gray), and then reinstall
the standard bobbin case (black).
CAUTION
• Be sure to use the bobbin case (gray) when creating
bobbin work. Using any other bobbin case may
result in the thread becoming tangled or damage to
the machine.
• Make sure that the bobbin case is correctly
installed. If the bobbin case is incorrectly installed,
the thread may become tangled or the machine may
be damaged.
h
Wind a decorative thread around the bobbin
by hand. After winding the bobbin so it is
filled as shown below (about 80%), cut the
thread.
For precautions on winding the bobbin for
embroidering, refer to step
Pattern" on page 13.
CAUTION
• Be sure to use the machine's included bobbin or one
designed specifically for this machine. Using any
other bobbin may result in damage or injuries.
11.5 mm
(approx.
7/16 inch)
This model
Note
• Slowly and evenly wind the thread around the
bobbin.
• For best results, wind the bobbin so the thread is
snug and not twisted.
b
of "Selecting the
Actual size
Other models
i
Using scissors carefully trim the thread tail as
close to the bobbin as possible.
a
Beginning of wound thread
CAUTION
• If thread extends beyond the top of the bobbin too
much, the thread may become tangled or the
needle may break.
j
Install the bobbin wound with thread.
Whether or not tension should be applied to the
bobbin thread depends on the type of thread
being used.
■ When tension is applied to the bobbin
thread
Insert bobbin into bobbin case so the thread unwinds
from the left side.
Then correctly pass the thread through the tension
spring as shown below.
a
Tension spring
7