Brother Quattro 6000D Kullanım Kılavuzu - Sayfa 8

Yazılım Brother Quattro 6000D için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Brother Quattro 6000D 29 sayfaları. Kit de actualización iii
Ayrıca Brother Quattro 6000D için: Manuel (42 sayfalar), Kullanım Kılavuzu (50 sayfalar), Kullanım Kılavuzu (6 sayfalar), Kullanıcı Kılavuzu (48 sayfalar), Kullanım Kılavuzu (21 sayfalar), (İngilizce) Kullanım Kılavuzu (49 sayfalar), (İngilizce) Kullanım Kılavuzu (21 sayfalar), (İngilizce) Kullanım Kılavuzu (48 sayfalar)

Sayfayı Yazdır

1. Troubleshooting

Note

• The bobbin case (gray) cannot be used for sewing in

any way other than bobbin work. After sewing

bobbin work, refer back to the steps in "Preparing

the Bobbin Thread" on page 6 for removing and

cleaning the bobbin case (gray), and then reinstall

the standard bobbin case (black).

CAUTION

• Be sure to use the bobbin case (gray) when creating

bobbin work. Using any other bobbin case may

result in the thread becoming tangled or damage to

the machine.

• Make sure that the bobbin case is correctly

installed. If the bobbin case is incorrectly installed,

the thread may become tangled or the machine may

be damaged.

Wind a decorative thread around the bobbin

by hand. After winding the bobbin so it is

filled as shown below (about 80%), cut the

thread.

For precautions on winding the bobbin for

embroidering, refer to step

Pattern" on page 13.

CAUTION

• Be sure to use the machine's included bobbin or one

designed specifically for this machine. Using any

other bobbin may result in damage or injuries.

11.5 mm

(approx.

7/16 inch)

This model

Note

• Slowly and evenly wind the thread around the

bobbin.

• For best results, wind the bobbin so the thread is

snug and not twisted.

of "Selecting the

Actual size

Other models

Using scissors carefully trim the thread tail as

close to the bobbin as possible.

Beginning of wound thread

CAUTION

• If thread extends beyond the top of the bobbin too

much, the thread may become tangled or the

needle may break.

Install the bobbin wound with thread.

Whether or not tension should be applied to the

bobbin thread depends on the type of thread

being used.

■ When tension is applied to the bobbin

thread

Insert bobbin into bobbin case so the thread unwinds

from the left side.

Then correctly pass the thread through the tension

spring as shown below.

Tension spring