Indesit MVK6 E21 RF Instrukcja obsługi - Strona 21

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kuchenki Indesit MVK6 E21 RF. Indesit MVK6 E21 RF 25 stron. Cooker and oven

Drukuj stronę

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity supply

before carrying out any work on it.

Cleaning the oven

! Never use steam cleaners or pressure cleaners on

the appliance.

•

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product,

then dry thoroughly with a soft cloth. Do not use

rough abrasive material or sharp metal scrapers

as these could scratch the surface and cause the

glass to crack.

• The stainless steel or enamel-coated external parts

and the rubber seals may be cleaned using a sponge

which has been soaked in lukewarm water and

neutral soap. Use specialised products for the

removal of stubborn stains. After cleaning, rinse and

dry thoroughly. Do not use abrasive powders or

corrosive substances.

• The inside of the oven should ideally be cleaned after

each use, while it is still lukewarm. Use hot water and

detergent, then rinse well and dry with a soft cloth. Do

not use abrasive products.

• The accessories can be washed like everyday

crockery, and are even dishwasher safe.

• Dirt and grease should be removed from the control

panel using a non-abrasive sponge or a soft cloth.

Stainless steel can be marked by hard water that

•

has been left on the surface for a long time, or by

aggressive detergents that contain phosphorus.

We recommend that the steel surfaces are rinsed

well then dried thoroughly.

Inspecting the oven seals

Check the door seals around the oven regularly. If the

seals are damaged, please contact your nearest After-

sales Service Centre. We recommend that the oven is

not used until the seals have been replaced.

Replacing the oven light bulb

reconnect the oven to the electricity supply.

1. After disconnecting the oven

from the electricity mains,

remove the glass lid covering

the lamp socket ( see figure ).

2. Unscrew the light bulb and

replace it with a similar one:

voltage 230 V, wattage 25 W,

cap E 14.

3. Replace the lid and

Assistance

! Never use the services of an unauthorised

technician.

Please have the following information to hand:

• The type of problem encountered.

• The appliance model (Mod.).

• The serial number (S/N).

The latter two pieces of information can be found on

the data plate located on the appliance.