A-Neuvideo ANI-0108POE Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przedłużacz A-Neuvideo ANI-0108POE. A-Neuvideo ANI-0108POE 12 stron. Hdmi poe 1x8 splitter over cat5e/6 extender
Również dla A-Neuvideo ANI-0108POE: Instrukcja obsługi (12 strony)

Drukuj stronę

NEUVIDEO

Wideband IR (30KHz---60KHz) introduction

Control a local device (Blu-ray player or DVD player, etc) from a remote: Connect the IR Receiver to the receiver IR input port. The CAT

output connector on the HDMI Splitter is connected via a CAT6 cable to a HDMI receiver. The IR Transmitter is connected to the HDMI

Splitter IR output. The IR remote can then be used to control a local source device.

IR RECEIVER (RX):

• To control the source: Plug IR Receiver into the IR RX port of the receiver unit. Place the receiver at or near the display.

IR BLASTER (TX):

• To control the source: Plug the IR Blaster into IR TX port of the transmitter unit. Place the blaster in front of the IR eye of the source.

CONNECT & OPERATE