A-Neuvideo ANI-0108POE Kullanım Kılavuzu - Sayfa 9

Genişletici A-Neuvideo ANI-0108POE için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. A-Neuvideo ANI-0108POE 12 sayfaları. Hdmi poe 1x8 splitter over cat5e/6 extender
Ayrıca A-Neuvideo ANI-0108POE için: Kullanım Kılavuzu (12 sayfalar)

Sayfayı Yazdır

NEUVIDEO

Wideband IR (30KHz---60KHz) introduction

Control a local device (Blu-ray player or DVD player, etc) from a remote: Connect the IR Receiver to the receiver IR input port. The CAT

output connector on the HDMI Splitter is connected via a CAT6 cable to a HDMI receiver. The IR Transmitter is connected to the HDMI

Splitter IR output. The IR remote can then be used to control a local source device.

IR RECEIVER (RX):

• To control the source: Plug IR Receiver into the IR RX port of the receiver unit. Place the receiver at or near the display.

IR BLASTER (TX):

• To control the source: Plug the IR Blaster into IR TX port of the transmitter unit. Place the blaster in front of the IR eye of the source.

CONNECT & OPERATE