Kohler FAMILY CARE S-TRAP K-23191T-NS Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Toalety Kohler FAMILY CARE S-TRAP K-23191T-NS. Kohler FAMILY CARE S-TRAP K-23191T-NS 10 stron. 3.0/4.8l vitreous china two piece toilet

Drukuj stronę

INSTALL THE TANK

Carefully turn the tank upside down

onto a protected surface. Fit the rubber

gasket over the flush valve nut.

Carefully position the tank on the bowl

by centering the gasket on the bowl

inlet. Line up the tank and bowl bolt

holes.

CAUTION: Risk of product

damage.

Overtightening may

cause breakage or chipping of

the vitreous china.

Install the bolt gaskets onto the tank

bolts, and slide the tank bolts down

through the holes in the tank and bowl.

Assemble the washers and nuts to the

tank bolts. Securely tighten the nuts so

the tank is level.

Be sure the nuts are tight enough to

achieve a watertight seal.

Carefully align and lower the bowl. Apply weight to the bowl

rim to let the outlet insert into plastic trap.

Carefully thread the screws into the brackets, until toilet is

secure. Alternately tighten left and right sides to prevent

pulling the toilet off center. Install cap to cover screw.

Do not overtighten.

Outlet

Plastic Trap

Apply caulk around base.

TO CONNECT WATER

SUPPLY

* Flexible hose are recommended to

connect the supply line to the fill valve.

If you use a rigid connection (not

provided), take care not to apply side

forces to the bottom of the fill valve. Be

sure the rigid connection must be fit

with supply line completely to prevent

damage shank by forced connection.

1402301-T01-B

Tank Bolt

Gasket

Tank

Bowl

Washer

Brass Nut

Viewing The

Assembly From

Under The Tank

Fig.#13

Supply Shank*

Fig.#16

-5-

Tank

Gasket

Bowl

Tank

Fig.#12

Bushing

Screw

Cap

Fig.#15

Supply Shut-Off Valve

Fig.#14

)

(