Kohler FAMILY CARE S-TRAP K-23191T-NS Kurulum Talimatları Kılavuzu - Sayfa 5
Tuvaletler Kohler FAMILY CARE S-TRAP K-23191T-NS için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler FAMILY CARE S-TRAP K-23191T-NS 10 sayfaları. 3.0/4.8l vitreous china two piece toilet
INSTALL THE TANK
Carefully turn the tank upside down
onto a protected surface. Fit the rubber
gasket over the flush valve nut.
Carefully position the tank on the bowl
by centering the gasket on the bowl
inlet. Line up the tank and bowl bolt
holes.
CAUTION: Risk of product
damage.
Overtightening may
cause breakage or chipping of
the vitreous china.
Install the bolt gaskets onto the tank
bolts, and slide the tank bolts down
through the holes in the tank and bowl.
Assemble the washers and nuts to the
tank bolts. Securely tighten the nuts so
the tank is level.
Be sure the nuts are tight enough to
achieve a watertight seal.
Carefully align and lower the bowl. Apply weight to the bowl
rim to let the outlet insert into plastic trap.
Carefully thread the screws into the brackets, until toilet is
secure. Alternately tighten left and right sides to prevent
pulling the toilet off center. Install cap to cover screw.
Do not overtighten.
Outlet
Plastic Trap
Apply caulk around base.
TO CONNECT WATER
SUPPLY
* Flexible hose are recommended to
connect the supply line to the fill valve.
If you use a rigid connection (not
provided), take care not to apply side
forces to the bottom of the fill valve. Be
sure the rigid connection must be fit
with supply line completely to prevent
damage shank by forced connection.
1402301-T01-B
Tank Bolt
Gasket
Tank
Bowl
Washer
Brass Nut
Viewing The
Assembly From
Under The Tank
Fig.#13
13
Supply Shank*
Fig.#16
-5-
Tank
Gasket
Bowl
Tank
Fig.#12
12
Bushing
Screw
Cap
Fig.#15
15
Supply Shut-Off Valve
16
Fig.#14
14
)
(