Kohler FAMILY CARE S-TRAP K-23191T-NS Kurulum Talimatları Kılavuzu - Sayfa 3

Tuvaletler Kohler FAMILY CARE S-TRAP K-23191T-NS için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler FAMILY CARE S-TRAP K-23191T-NS 10 sayfaları. 3.0/4.8l vitreous china two piece toilet

Sayfayı Yazdır

INSTALLATION

TO REMOVE EXISTING TOILET
Turn off the water supply. Flush the toilet, and use a sponge
to remove the remaining water from the tank and bowl.
Disconnect the supply shut-off valve (if present), and remove
the old tank and bowl.
Remove the old gasket from the floor
and the closet flange with a putty knife.
Remove the old T-bolts and discard
them.
NOTICE:
if the new toilet is not
installed immediately, temporarily stuff
a rag into the closet flange.
NOTICE: Do not use white cement or high lime content
cements to install this toilet. The expansion of cement due to
a rise in temperature may make the toilet crack or cause
damage. Kohler is not responsible for any damage caused by
installation with the use of cement.
TO INSTALL SUPPLY
SHUT-OFF VALVE
Install the supply shut-off valve so it is
229mm above the finished floor line,
and 200mm to the left of the closet
flange centerline.
The centerline of the supply shut-off
valve outlet should extend 67mm from
the finished wall. Install the supply
shut-off valve with the outlet vertical.
TO INSTALL BOWL
Position the template and align with drain hole.
Mark down the position of foot and 5 holes.
Drill holes on ground with the drill of 10mm (3/8"), then insert
anchor to holes.
CAUTION:
Please make sure there is no water pipe or spool
under the 5 holes to be drilled.
Install brackets.
1402301-T01-B
229
305/400
Drain Hole
Fig.#4
4
Fig.#6
6
Fig.#2
Closet Flange
2
Supply Shut-Off Valve
200
Closet Flange
Centerline
Fig.#3
3
10mm
Fig.#5
5
-3-
(
)
229mm
5
3/8
10mm
T
200mm
67mm;