Kohler 14RESL Instrukcja instalacji - Strona 28

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przenośny generator Kohler 14RESL. Kohler 14RESL 48 stron. Residential and light commercial generator sets
Również dla Kohler 14RESL: Instrukcja rozwiązywania problemów (8 strony)

Drukuj stronę
Kohler 14RESL Instrukcja instalacji

1.11 Accessories

Have accessories installed by an authorized distributor/
dealer or a licensed electrician. Follow the installation
instructions provided with each kit. Use separate conduit
for AC and DC leads to reduce the possibility of electrical
interference. Verify that the leads and conduit do not
interfere with the operation of the generator set or
obstruct the service areas. Verify that the electrical
installation complies with the National Electrical Code
(NEC) and all applicable local codes. See Section 2,
Wiring Diagrams, for more information regarding
generator set electrical connections.

1.11.1 Regulator Heater

The regulator heater kit is designed for Model 20RES
and 20RESL generator sets. The regulator heater kit is
recommended in addition to the carburetor heater for
reliable engine starting in temperatures below --18_C
(0_F). See Figure 1-24 for heater specifications.
Regulator Heater
Heater rating
120 VAC, 60 W
_
Thermostat
4
C/13
Pad diameter
127 mm (5 in.)
Cord length
610 mm (24 in.)
Figure 1-24 Regulator Heater Specifications
The regulator heater requires a source of 120 VAC
power. The generator set is equipped with two 120 VAC
receptacles, one of which is used for the battery charger.
If another accessory such as the carburetor heater or
battery heater is also used, the installer will need to
provide another receptacle for the regulator heater. The
circuit should be ground fault protected.
To install the regulator heater kit, follow the instructions
in TT-1569, provided with the kit. Figure 1-25 shows the
installed regulator heater kit.
28
Section 1 Installation
_
_
_
(
C
40
F/55
F) Snap action
1
2
3
1. Regulator heater pad GM79142
2. Regulator mounting screws M933-06035-60, qty. 2
(re-use existing nuts)
3. Heater power cord
Figure 1-25 Installed Regulator Heater Kit, shown
with original fuel system
(for 20RES/RESL)
GM79141
TP-6733 8/11