Kohler 14RESL Instrukcja instalacji - Strona 30

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przenośny generator Kohler 14RESL. Kohler 14RESL 48 stron. Residential and light commercial generator sets
Również dla Kohler 14RESL: Instrukcja rozwiązywania problemów (8 strony)

Drukuj stronę

1.12 Prestart Installation Check

Review the entire installation section. Inspect all wiring

and connections to verify that the generator set is ready

for operation. Check all items in the following Prestart

Checklist.

Prestart Checklist

Air Cleaner. Check that a clean air cleaner element is

installed to prevent unfiltered air from entering the

engine. See the generator set operation manual for

instructions.

Air Inlets. Check for clean and unobstructed air inlets.

Battery. Check for tight battery connections. Consult

the battery manufacturer's instructions regarding

battery care and maintenance.

Enclosure.

Check that all enclosure panels and

internal baffling are in place.

Exhaust System.

Check for exhaust leaks and

blockages. Check the muffler condition.

Inspect the exhaust system components for cracks,

leaks, and corrosion. Check for tight exhaust system

connections.

Check for corroded or broken metal parts and replace

them as needed.

Check that the exhaust outlet is unobstructed.

Oil Level. Maintain the oil level at or near, not over, the

full mark on the dipstick.

Operating Area. Check for obstructions that could

block the flow of cooling air. Keep the air intake area

clean. Do not leave rags, tools, or debris on or near the

generator set.

Section 1 Installation

1.13 Set Exerciser

Set the exerciser to automatically run the generator set

on the desired day and time every week. See TP-6734,

Operation Manual, for detailed descriptions of the

unloaded and loaded exercise operation.

Procedure to Set the Exerciser

1. Press the AUTO button on the controller.

2. Press the down arrow button (RDC) or the exercise

button (DC) to start an unloaded exercise. The

engine starts and runs a 20-minute unloaded

variable-speed exercise with system diagnostics.

EnLd is displayed.

3. If the generator set is connected to a Kohlerr Model

RRT transfer switch, the exercise can be changed

to a loaded exercise by pressing the down arrow

button (RDC) or the exercise button (DC) again

after the engine has started. E Ld is displayed.

4. After 20 minutes, verify that the exercise ends and

the engine shuts down automatically.

loaded exercise, the engine runs for 5 minutes or

until cool, and then shuts down.

The exercise will run every seven days at the same time

that the exercise was started.

Other transfer switches: For a loaded exercise with a

transfer switch other than a Kohlerr Model RRT, refer to

the transfer switch operation manual for instructions.

After a

TP-6733 8/11