Aqua Creek Products F-004PLB-XR Podręcznik - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik dla Systemy podnoszenia Aqua Creek Products F-004PLB-XR. Aqua Creek Products F-004PLB-XR 20 stron.

a. NOTE: It is recommended to apply tape to the bottom of the anchor plate

around the holes so when the epoxy oozes out of the holes it does not

secure the anchor plate to the pool deck.

7. Allow for a way to bond at least one of the anchor inserts according to your local code

requirements. This is typically accomplished with 8-AWG solid-copper wire attached to the

pool's bonding grid. For more information see NEC Article 680.26.

8. Before putting epoxy into the holes and setting the anchor inserts, test t the anchor inserts in

the pre-drilled holes rst to make sure they line up properly. Pick up the anchor plate with the

three (3) anchor bolts attached to the underside and carefully place them into the three holes

drilled in the deck. Using a torpedo level on the plate, verify the anchor system is level. If they

do not line up you may have to enlarge your holes.

9. After verifying the anchor inserts line up with the holes properly and the anchor assembly is

level, remove the anchor assembly and ll each hole in the pool deck at least half full of two

part construction epoxy (not included). Aqua Creek recommends either Hilti™ Brand RE-500-SD or

an alternative approved adhesive.

10. Pick up the anchor assembly with the three (3) anchor bolts attached to the underside and

carefully place them into the holes drilled in the deck. When placing the anchor bolts attached

to the anchor plate, wiggle the jig-plate assembly a little to make sure the epoxy gets on all

sides of the anchor bolts.

11. Once the anchor bolts are placed into the holes, use a small torpedo level on the anchor plate to

make sure they are level and perpendicular.

FIGURE 4

12. Allow the epoxy to set up

according to the manufacturer's

recommendations and remove

the hardware and the anchor

jig-plate. The lift can now safely

mount to the anchors using the

same hardware used to mount the

anchor inserts to the underside of

the anchor jig-plate. The anchor

jig-plate can be recycled or used

for installing a second set of

anchors in another location.

Revised 11/20/14

V.1.1