Aqua Creek Products F-004PLB-XR Podręcznik - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik dla Systemy podnoszenia Aqua Creek Products F-004PLB-XR. Aqua Creek Products F-004PLB-XR 20 stron.

NOTE: FOR DECKS 6" THICK OR MORE, 2500PSI MINIMUM STRENGTH CONCRETE REQUIRED

Core drill and 1 ½" core drill bit

Marking pen

Cold chisel

Masking tape

Black electrical tape (optional)

*Aqua Creek recommends either Hilti™ Brand HIT RE-500-SD or Simpson™ brand SET-XP or equivalent (not included)

1. Locate the anchor jig-plate, and three (3) anchor bolts with mounting hardware. (If sold

separately from lift, part number F-910SAJP).

2. Using the larger holes in the anchor jig-plate as a template, mark the three hole locations with

a marking pen on the pool deck. Verify the CENTER LINE OF THE ANCHORS are no more than 38

inches from the pools edge. See FIGURE 1, page 4.

3. Using the core drill and the 1 1/2" core drill bit, drill out the three hole locations marked on the

pool deck to a depth of about 4 1/2".

bolts are ush with the BOTTOM of the jig-plate (see diagram on left). IMPORTANT: Use the

enclosed packet of anti-seize lube on the threads of the hardware to prevent the hardware from

seizing in the anchor inserts.

Required Tools:

Tape measure

Hammer

Torpedo level

High strength 2-part construction epoxy*

a. NOTE: Use black electrical tape on the end of the

drill bit as a visual marker to indicate the proper depth needed

to drill to.

b. NOTE: Depending on local grounding requirements,

one hole may need to be drilled larger than the others so

at least one of the anchor inserts is grounded. One anchor insert is

provided with a bonding screw to assist with this step. In some

cases saw cutting a portion of the deck out

completely might be required. In this case, follow the "Saw

Cutting Retro-Fit Instructions".

4. Remove the core from the holes using a hammer and chisel.

The holes should be completely dry and clear of any debris

before installing the anchors into them.

5. Remove the nuts from the threaded anchor bolts and the black

protective cover from the end of the anchor bolt, exposing the

internal threads that will accept the mounting hardware.

6. Using the smaller holes in the anchor jig-plate, thread the

mounting hardware through the anchor jig-plate holes and

into the ends of the three anchor bolts so the tops of the

continued on page 6

Revised 11/20/14

V.1.1