Aqua Laser 46904 Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odkurzacz Aqua Laser 46904. Aqua Laser 46904 13 stron.

Brush head assembly

Firmly hold the scrubber head

assembly with one hand and then

press the selected scrubber head

on until secured.

To join both together, line up the

openings on the brush head with

the openings on the srubber head

assembly. See the arrows.

To attach one of the microfiber pads, press the white side of the pad to the microfiber pad holder.

Microfiber pads can be machine washed on a gentle cold cycle with a mild detergent. Allow microfiber pads

to air dry, do not place them in the dryer.

How to use

1. Apply water and a cleaning agent to the surface to be cleaned.

2. To start cleaning, turn the ON/OFF switch to the ON position while the scrubber head is in contact

with the surface to be cleaned. Hold the unit by its handle and gently press the scrubbing head to

the surface to be cleaned. Do not press too hard. The product has been specially designed to do all

the scrubbing work.

3. Not waterproof. Do not dip the brush head or unit in liquids.

4. Prior to cleaning, try the brush on inconspicuous location on the surface to be cleaned.

5. Operate the Turboscrubber brush only when it is touching the area being cleaned in order to limit

spraying user and bystanders.

6. Cleaning chemicals must only be used in accordance with the instructions from the chemical

manufacturers and the instructions from the manufacturers of the surface being cleaned. Abrasive

cleaners should never be used.

Charging

1. Set ON/OFF switch to the OFF position.

2. Remove the charging cover to expose the charging port. Do not separate the charging cover from

the device.

3. Insert the adapter plug into the charging port, located at the bottom of the unit.

4. Plug the charging adapter directly into a standard power outlet.

a. A solid red light on the adapter means charging is occurring.

b. A solid green light on the adapter means the unit is fully charged.

5. If the unit does not charge, test the wall outlet that you are using with a know working device. Also,

if the wall outlet is connected to a wall switch, check and see that the switch is turned to the ON

position.

6. If the unit's handle feels warm during charging, do not worry, this is completely normal.

7. Do not worry, you cannot over-charge the battery by using the provided charging adapter.

8. Replace the charging cover to protect the

charging port once charging is complete.

9. Do not operate the unite while charging.

Keep the unit OFF during the charging

process.