AVPro Edge AC-EX70-UHD-KIT Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przedłużacz AVPro Edge AC-EX70-UHD-KIT. AVPro Edge AC-EX70-UHD-KIT 19 stron. Ultra slim 4k hdmi via hdbaset 70 meter extender
Również dla AVPro Edge AC-EX70-UHD-KIT: Skrócona instrukcja obsługi (4 strony)
Drukuj stronę
If the BLUE HDMI SIGNAL LIGHT is flashing, check the following:
· The source. Plug it directly into the display to be sure it's functioning properly.
· Try a longer HDMI cable. Some HDMI cables do not sync well at shorter lengths, a 2 meter
minimum is recommended per HDMI Specifications.
· Set the EDID to state #1 (See Page[s] 12).
· Contact AVProEdge if these suggestions do not work.
STATUS - On front by HDMI Port: (Blue) This indicator shows that the HDMI
source is connected. The states are:
· Light Is On (Solid) = Sync w/ HDMI source is correct and solid.
· Light Is Flashing = The light flashes during the sync process. If it is flashing continuously, a
picture may not be present.
If the BLUE HDMI SIGNAL LIGHT is flashing, check the following:
· The source. Plug it directly into the display to be sure it's functioning properly.
· Try a longer HDMI cable. Some HDMI cables do not sync well at shorter lengths, a 2 meter
minimum is recommended per HDMI Specifications.
· Set the EDID to state #1 (See Page[s] 11).
· Contact AVProEdge if these suggestions do not work.
LINK above the RJ45 (HDBaseT) Port:
HDBaseT link between the Tx and Rx is intact. This light should ALWAYS be solid. If
this light is flashing or not present attempt the following:
· Check the length. The maximum distances are 40m (131ft) on 4K and 70m
(230ft) on 1080P.
· Remove any coils of cable and make sure that there is not excess cabling.
· Bypass all patch panels and punch-down blocks.
· Re-terminate connectors. Sometimes, even if a cable tester indicates the run is valid,
something may be slightly off.
· Contact AVProEdge if these suggestions do not work.
(Green)
This indicator shows that the
6