Aqua Quip AQUA-STAR Instrukcje instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Oświetlenie basenu Aqua Quip AQUA-STAR. Aqua Quip AQUA-STAR 4 stron.
Drukuj stronęHousing Installation – see Diagram 1
1 Aqua-Star Housing should be tied to the steel reinforcing,
before concreting the pool. A red Concrete Cap is supplied
to fit inside the front of the Housing prior to concreting.
2 The Housing has two conduit connection points to
accept rigid PVC conduit, do not use flexible conduit.
Choose the appropriate provision for the situation and run
conduit above water level to form an anti-siphon loop. Top
provision accepts 20mm conduit or 25mm conduit fitting.
Rear provision accepts 20mm coupling. If using the Rear
Provision, be sure to plug the Top Provision using a 25mm
conduit cap.
3 Use tie wire or cable ties through the holes on the outer
perimeter of the Housing to securely fasten it to the steel
reinforcing bars. Position the Housing so that the front will
finish level with the concrete.
4 It is very important to locate Housing at a suitable location
and depth to allow for future servicing of the pool light.
Excavate sufficiently around the rear of the Housing to allow
approximately 100mm of concrete to encase it. If pool is out
of ground and fully formed, ensure the formwork allows for
concrete to encase the Housing.
5 During pouring/spraying, concrete should be undercut
around the front perimeter of the Housing to allow for a
construction adhesive to be applied prior to the application
of the internal pool surface.
6 Concrete should be applied to reduce the likelihood of
a void occurring on the underside of the Housing. Once
concrete has cured, construction adhesive must be applied
around the Housing to seal it to the concrete.
TECHNICAL SPECIFICATIONS AQUA-STAR HALOGEN FLUSH MOUNTED POOL LIGHTS
Nominal Supply Voltage:
Voltage Tolerance:
Protection Rating:
Temperature Range:
Power Consumption:
Lamp Life:
Light Output (typical):
Aqua-Star Halogen Lights must only be operated underwater as they are water-cooled.
Install in an accessible location, ensure that sufficient cable is wound up inside the housing to allow the light to be
floated to the deck level. If being installed facing up, ensure that there is minimum 100mm of water cover and change
globe to max 30 watts.
Aqua-Star Halogen Pool Lights can be installed on a vertical or horizontal pool surface. Up to 1.6m of cable can be
wound up inside the Concrete Housing.
2
A Q U A - S T A R H A L O G E N L I G H T S F O R C O N C R E T E P O O L S – I N S T A L L AT I O N I N S T R U C T I O N S & O W N E R S M A N U A L
AQUA-STAR HALOGEN
HOUSING INSTALLATION
12V AC 50/60 Hz
+2%, -10%
IPX8 (to 2.0m depth)
-10°C ~ +40°C water temperature
50 VA
2,000 hours
900 Lumens
LIGHTS FOR
CONCRETE POOLS
Alternative
Conduit
Provision
100mm
Concrete
Encasement
Concrete
Diagram 1 – After Concreting
Undercut