Aqua Quip AQUA-STAR Istruzioni per l'installazione - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Illuminazione della piscina Aqua Quip AQUA-STAR. Aqua Quip AQUA-STAR 4.

Stampa la pagina

Housing Installation – see Diagram 1

1 Aqua-Star Housing should be tied to the steel reinforcing,

before concreting the pool. A red Concrete Cap is supplied

to ﬁt inside the front of the Housing prior to concreting.

2 The Housing has two conduit connection points to

accept rigid PVC conduit, do not use ﬂexible conduit.

Choose the appropriate provision for the situation and run

conduit above water level to form an anti-siphon loop. Top

provision accepts 20mm conduit or 25mm conduit ﬁtting.

Rear provision accepts 20mm coupling. If using the Rear

Provision, be sure to plug the Top Provision using a 25mm

conduit cap.

3 Use tie wire or cable ties through the holes on the outer

perimeter of the Housing to securely fasten it to the steel

reinforcing bars. Position the Housing so that the front will

ﬁnish level with the concrete.

4 It is very important to locate Housing at a suitable location

and depth to allow for future servicing of the pool light.

Excavate sufﬁciently around the rear of the Housing to allow

approximately 100mm of concrete to encase it. If pool is out

of ground and fully formed, ensure the formwork allows for

concrete to encase the Housing.

5 During pouring/spraying, concrete should be undercut

around the front perimeter of the Housing to allow for a

construction adhesive to be applied prior to the application

of the internal pool surface.

6 Concrete should be applied to reduce the likelihood of

a void occurring on the underside of the Housing. Once

concrete has cured, construction adhesive must be applied

around the Housing to seal it to the concrete.

TECHNICAL SPECIFICATIONS AQUA-STAR HALOGEN FLUSH MOUNTED POOL LIGHTS

Nominal Supply Voltage:

Voltage Tolerance:

Protection Rating:

Temperature Range:

Power Consumption:

Lamp Life:

Light Output (typical):

Aqua-Star Halogen Lights must only be operated underwater as they are water-cooled.

Install in an accessible location, ensure that sufficient cable is wound up inside the housing to allow the light to be

floated to the deck level. If being installed facing up, ensure that there is minimum 100mm of water cover and change

globe to max 30 watts.

Aqua-Star Halogen Pool Lights can be installed on a vertical or horizontal pool surface. Up to 1.6m of cable can be

wound up inside the Concrete Housing.

A Q U A - S T A R H A L O G E N L I G H T S F O R C O N C R E T E P O O L S – I N S T A L L AT I O N I N S T R U C T I O N S & O W N E R S M A N U A L

AQUA-STAR HALOGEN

HOUSING INSTALLATION

12V AC 50/60 Hz

+2%, -10%

IPX8 (to 2.0m depth)

-10°C ~ +40°C water temperature

50 VA

2,000 hours

900 Lumens

LIGHTS FOR

CONCRETE POOLS

Alternative

Conduit

Provision

100mm

Concrete

Encasement

Concrete

Diagram 1 – After Concreting

Undercut