Abatement Technologies AIRE GUARDIAN AG8000 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt budowlany Abatement Technologies AIRE GUARDIAN AG8000. Abatement Technologies AIRE GUARDIAN AG8000 20 stron. Hard-sided mobile containment unit

Drukuj stronę

Removing the fabric enclosure and top cover

Installing an RPM series pressure monitor

Both the top cover and the fabric enclosure are fastened

to the mobile containment unit via hook and loop. To

remove the top cover, simply separate the hook and

loop along the perimeter of the top cover. To remove

the fabric enclosure, detach the hook from the loop from

each of the four telescoping members as shown above.

Then separate the hook and loop along the top

perimeter and then the bottom perimeter.

Locate

bracket on the inside back wall of the

AG8000.

Remove the faceplate from the RPM series

pressure monitor by unscrewing the two small

screws on the sides of the pressure monitor.

Connect the reducing elbow to the "COM"

port of the monitor and attach tubing to the

other side of the elbow. Plug the power

connector into the terminal as shown. Hang

the monitor on the lower set of screws on the

mounting bracket.

Plug the tubing into the barb located in the

polycarbonate panel of the back wall.

Reattached the faceplate to the monitor by

tightening the two screws on the sides. Plug

the power adapter into one of the standard

120V receptacles inside the AG8000.

the

pressure monitor

mounting