Dell Inspiron 600m Instrukcja serwisowa - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Laptop Dell Inspiron 600m. Dell Inspiron 600m 40 stron. Hard drive
Również dla Dell Inspiron 600m: Zacznij tutaj (2 strony), Zacznij tutaj (2 strony), Zacznij tutaj (2 strony), Podręcznik dla początkujących (2 strony), Podręcznik użytkownika (34 strony), Instrukcja konfiguracji (2 strony), Pierwsze kroki (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja serwisowa (41 strony), Podręcznik użytkownika bazy multimedialnej (26 strony), Instrukcja serwisowa (41 strony), Instalacja i konfiguracja (38 strony), Szybki start (2 strony), Szybki start (2 strony), Szybki start (2 strony), Konfiguracja komputera (2 strony), Instrukcja serwisowa (41 strony), Instrukcja serwisowa (4 strony)

Dell Inspiron 600m Instrukcja serwisowa
Back to Contents Page
  Hard Drive
Dell™ Inspiron™ 700m Service Manual 
  Replacing the Hard Drive
  Returning a Hard Drive to Dell
 Replacing the Hard Drive
 
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
Disconnect the computer and any attached devices from electrical outlets.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE:
Read
"Before Working Inside Your
 
1. Remove the battery.
 
2. Loosen the three captive screws that secure the hard drive to the bottom case.
NOTE:
Rubber grommets secure each screw to the hard drive so that you do not need to completely remove the screws.
1 captive screws (3)
2 hard drive cover
NOTICE:
When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting Against Electrostatic Discharge" in the
Product Information Guide.
 
3. Loosen the two captive screws on the hard drive securing bracket and remove the bracket.
 
4. Pull the hard drive out of the computer using the pull tab.
Computer" before performing the following procedure.