ensto eFiller Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ładowarka ensto eFiller. ensto eFiller 12 stron.

5.2 The indicator light is red

Potential errors and corrective actions:

•

Unsupported configuration on the eFiller charging current limitation. Check the position

on the DIP switches inside the charging point according to the table on page 7.

Notice that opening the cover can only be done by electrically skilled person.

•

Missing protective earth (PE). Check the PE availability from the supply line and condition

of the charging cable.

•

Error in the vehicle communication. Disconnect the vehicle, reset the charging point by

turning supply voltage off and on. Retry charging.

•

Software error. Disconnect the vehicle, reset the charging point by turning supply voltage

off and on. Retry charging.

•

The vehicle requires ventilation. In case the vehicle requires ventilation during charging,

eFiller does not allow charging.

•

Ensure from the vehicle that the vehicle has no timer charging activated. If the timer

charging is activated, the charging time may be different than expected.

•

Ensure from inside of the charging point the configuration of the current limitation DIP

switches. If the charging current limitation is set to a lower charging current than as-

sumed, the charging time is longer.

Notice that opening the cover can only be done by electrically skilled person.

•

Ensure that there is no charging current limitation features in use at the vehicle.

If you need to contact Ensto related to faulty operation of eFiller, please prepare to tell the

order number (V.......). You will find the order number on the nameplate on the enclosure bot-

tom.

With well-done maintenance you can ensure a long lifetime of the charging point and keep the

warranty valid.

Please proceed the following maintenance once in a month:

•

Test the residual current device (RCD-B) at the supply line. Usually RCD's have a test but-

ton for this purpose. There might be local requirements on the RCD manual test interval,

but Ensto recommends testing once a month. In case of failed test the RCD must be

changed.

•

Check the plug holder and the charging plug from possible dirt. Remove possible dirt.

•

Check the condition of the charging plug and the charging cable for wear out or mechani-

cal damage. If damaged, please replace necessary parts with new ones.