Dell PowerApp 110 Instrukcja instalacji - Strona 21

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Serwer Dell PowerApp 110. Dell PowerApp 110 34 stron. Rack installation guide

support.dell.com

Before You Begin

Before you begin installing your PowerApp appliance in the rack, carefully read "Safety

Instructions" , found earlier in this guide.

NOTICE: This rack kit is intended to be installed in a Dell rack by trained

service technicians. If you install the kit in any other rack, be sure that the

rack meets the specifications of American National Standards Institute

(ANSI)/Electronic Industries Association (EIA) standard ANSI/EIA-310-D-92,

International Electrotechnical Commission (IEC) 297, and Deutsche Indus-

trie Norm (DIN) 41494. One rack kit is required for each Dell server,

storage system, or appliance that is installed in a rack.

You need the following tools and supplies to install the appliance in a four-post rack

cabinet:

•

A #2 Phillips screwdriver

•

A flat-blade screwdriver

•

Masking tape or a felt-tip pen, for use in marking the mounting holes to be used

NOTES: If you purchased a Dell rack along with your PowerApp appliance, the slide

assemblies may be preinstalled in the rack.

For instructions on installing the PowerApp appliance itself, see "Installing the

Appliance in the Rack" found later in this guide.

To install the slide assemblies in the rack, perform the following steps:

Remove the rack's front and back doors.

Install the slide assemblies in the rack.

The subsections that follow include instructions for performing these tasks.

Rack Installation Guide

1-13