Dell PowerEdge 1855 Aktualizacja informacji
Przeglądaj online lub pobierz pdf Aktualizacja informacji dla Serwer Dell PowerEdge 1855. Dell PowerEdge 1855 2 stron. Using dell blade servers in a dell poweredge high availability cluster
Również dla Dell PowerEdge 1855: Skrócona instrukcja obsługi (12 strony), Instrukcja obsługi (44 strony), Podręcznik użytkownika (33 strony)
Drukuj stronę
C8552am1.fm Page 1 Monday, November 22, 2004 1:08 PM
Information Update
™
For instructions on installing your Dell
2342M Integrated Fibre Channel Module, refer to the
™
PowerEdge
1855 Installation and Troubleshooting Guide. Configuration information, drivers, and
a list of EMC-approved software are available on support.dell.com.
®
®
Using the StorPort Driver with the Microsoft
Windows
Server 2003 Operating System
If you are using the StorPort driver with the Microsoft Windows Server 2003 operating system and
do not have Service Pack 1 or later installed, make sure you are using the latest storport.sys driver.
Updated StorPort drivers are available from www.microsoft.com. Refer to the EMC Support Matrix
(ESM) at www.emc.com for the latest required hotfix.
QLogic SANblade Manager Application
At present, the QLogic SANblade Manager application does not support the Dell 2342M
Integrated Fibre Channel Module daughter card for the PowerEdge 1855. When complete, drivers
will be available at support.dell.com.
If you need to implement Target Persistent Bindings, download the SANblade CLI available at
www.qlogic.com in the EMC Approved Software section.
High Availability Clustering with Microsoft Cluster Server
High availability clustering with Microsoft Cluster Server (MSCS) is not supported. Support for
this feature is planned for Q1 2005.
Boot from SAN Option
Under certain SAN configurations, the Hard Disk Drive Sequence setting under BIOS Setup will
display as Embedded, followed by random ASCII characters. This truncated ASCII string
represents the external SCSI TARGET/LUN combination. Select this string to boot your system.
Despite this message, the Boot from SAN function works properly. A future version of the option
ROM (version 1.46 or later) for your fibre channel module will eliminate this issue. When
completed, this update will be available on support.dell.com.
November 2004