Dell PowerEdge 1855 Інформаційне оновлення

Переглянути онлайн або завантажити pdf Інформаційне оновлення для Сервер Dell PowerEdge 1855. Dell PowerEdge 1855 2 сторінки. Using dell blade servers in a dell poweredge high availability cluster
Також для Dell PowerEdge 1855: Посібник із швидкого старту (12 сторінок), Посібник з використання (44 сторінок), Посібник користувача (33 сторінок)

C8552am1.fm Page 1 Monday, November 22, 2004 1:08 PM

Information Update

™

For instructions on installing your Dell

2342M Integrated Fibre Channel Module, refer to the

™

PowerEdge

1855 Installation and Troubleshooting Guide. Configuration information, drivers, and

a list of EMC-approved software are available on support.dell.com.

Using the StorPort Driver with the Microsoft

Windows

Server 2003 Operating System

If you are using the StorPort driver with the Microsoft Windows Server 2003 operating system and

do not have Service Pack 1 or later installed, make sure you are using the latest storport.sys driver.

Updated StorPort drivers are available from www.microsoft.com. Refer to the EMC Support Matrix

(ESM) at www.emc.com for the latest required hotfix.

QLogic SANblade Manager Application

At present, the QLogic SANblade Manager application does not support the Dell 2342M

Integrated Fibre Channel Module daughter card for the PowerEdge 1855. When complete, drivers

will be available at support.dell.com.

If you need to implement Target Persistent Bindings, download the SANblade CLI available at

www.qlogic.com in the EMC Approved Software section.

High Availability Clustering with Microsoft Cluster Server

High availability clustering with Microsoft Cluster Server (MSCS) is not supported. Support for

this feature is planned for Q1 2005.

Boot from SAN Option

Under certain SAN configurations, the Hard Disk Drive Sequence setting under BIOS Setup will

display as Embedded, followed by random ASCII characters. This truncated ASCII string

represents the external SCSI TARGET/LUN combination. Select this string to boot your system.

Despite this message, the Boot from SAN function works properly. A future version of the option

ROM (version 1.46 or later) for your fibre channel module will eliminate this issue. When

completed, this update will be available on support.dell.com.

November 2004