Dell PowerEdge systems 6300 Informacje o instalacji - Strona 3

Przeglądaj online lub pobierz pdf Informacje o instalacji dla Serwer Dell PowerEdge systems 6300. Dell PowerEdge systems 6300 6 stron. Systems 1 x 2 backplane
Również dla Dell PowerEdge systems 6300: Informacje o instalacji (6 strony), Instrukcja instalacji (28 strony), Instalacja stojaka (37 strony), Podręcznik użytkownika (42 strony), Instrukcja instalacji (8 strony), Instalacja stojaka (34 strony), Instrukcja instalacji (12 strony), Instrukcja wymiany (3 strony)

All manuals and user guides at all-guides.com

,QVWDOOLQJWKH'ULYH&DJH

To install the drive cage, perform the following steps:

Ensure that the drive cage is correctly assembled:

Verify that the 1 x 2 backplane is connected to the edge of the auxiliary SCSI

backplane via a 100-pin connector.

Verify that the auxiliary SCSI backplane is inserted into the enclosure on the

side of the cage and secured with one screw.

Verify that the 1 x 2 backplane is secured to the back of the cage with four

screws.

Verify that a drive rail is attached to each side of the drive cage.

Insert the drive cage into the empty peripheral drive bay until the clips on the

drive rails snap into the sides of the peripheral drive bay (see Figure 1).

drive cage

drive rail

clip

)LJXUH,QVWDOOLQJWKH'ULYH&DJH

,QVWDOOLQJWKH,

&([WHQVLRQ&DEOH

To install the I

C extension cable, perform the following steps:

Disconnect the I

C cable from the 20-pin connector on the system board and set

it to one side (see Figure 2).

Dell PowerEdge 6300 and 4300 Systems 1 x 2 Backplane Installation Information3