Dell PowerVault 715N Instrukcja serwisowa - Strona 18
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Przechowywanie Dell PowerVault 715N. Dell PowerVault 715N 44 stron. Network attached storage
Również dla Dell PowerVault 715N: Instrukcje aktualizacji (4 strony), Podręcznik użytkownika (31 strony)
Drukuj stronę
4. Insert the replacement hard drive into the carrier and install the screws you removed in step 2a to secure the drive.
NOTICE:
Ensure that the hard drive's power cables do not extend beyond the outside (left) edge of the carrier,
which might cause damage to the wires.
5. Open the handle on the carrier and install the replacement hard drive and carrier into its slot in the drive bay (see
Figure
4).
6. Close the handle until it engages the front panel, locking the drive in place.
7.
Replace the
bezel.
8. Run the
system diagnostics
9. Follow the appropriate procedure for restoring your data and adding mirrors in the section, "Managing Hard Drives"
in the System Administrator's Guide.
Control Panel Board
In
Figure
6, the control panel is shown removed from the system chassis.
Figure 6. Control Panel Removal
2 Power connector
3 Interface cable
4 Hard-drive carrier
5 Screws (4)
to test and prepare the new drive.
1 6-32 x 0.25-inch Phillips screw (3)
2 Midplane connector (JP5)
3 Ribbon cable connector
4 Control panel board