Miller Coolmate 3 CE Instrukcja obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System spawania Miller Coolmate 3 CE. Miller Coolmate 3 CE 20 stron.
Drukuj stronę
SECTION 6 − MAINTENANCE & TROUBLESHOOTING
6-1. Routine Maintenance
n = Check
* To be done by Factory Authorized Service Agent
Every
~
3
Months
tions may require more frequent cleaning
(continuous use, high/low temperatures,
dirty environment, etc.). Failure to properly
clean coolant strainer voids pump warranty.
Every
6
Months
nlHoses
Every
Change
12
Coolant (If
Months
Using Miller
Coolant)
ZReplace coolant.
6-2. Coolant Maintenance
1
OM-628 Page 10
.
A complete Parts List is available at www.MillerWelds.com
Z = Change
~ = Clean
Clean coolant strainer. Severe condi-
nl Labels
Δ = Repair
~ Blow out heat exchanger fins.
nCheck coolant level. Top off with
distilled or deionized water if necessary.
Change
Coolant (If
Using Water)
ZReplace coolant.
Tools Needed:
3/8 in.
Ref. 801194 / 801189-E
!
Disconnect power
before maintaining.
l = Replace
!
Disconnect cooler plug from
welding power source receptacle
before maintaining.
!
Dispose of used coolant accord-
ing to national, state, and local
codes. Do not pour down drain.
1
Coolant Filter
Unscrew housing to clean filter and
housing.
Changing Coolant
Drain coolant by tipping unit forward. Fill
with clean water and run for 10 minutes.
Drain and refill.
NOTICE − If replacing hoses, use hoses
compatible with ethylene glycol, such as
Buna-n,
Neoprene,
or
Hypalon.
Oxy-acetylene hoses are not compati-
ble with any product containing ethylene
glycol.