Diamatic BS-110 MKIII Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Diamatic BS-110 MKIII. Diamatic BS-110 MKIII 16 stron.

6. Maintenance

Wheel scraper plates

Keep wheels clean from dirt/debris. To adjust the scraper plates unplug

electrical supply cable and loosen the bolts. Slide up to face wheel until it

touches but does not dig into the wheel surface.

Over tightening scraper plates could cause damage to wheel.

To replace the shock absorbers first remove the weights as described on

previous page. Unscrew the 6 bolts of the bottom cover, then remove bottom

cover. Unscrew the five M10 nuts of the cutting head and remove cutting

head. Remove the five big washers on shock absorbers. Unscrew the bolts of

the shock absorbers at top. Replace shock absorbers with the new ones and

apply Loctite on bolts to secure them. Put the five big washers on the shock absorbers. Carefully place the

cutting head on the shaft. Do not use hammer to prevent damage to the bearings. Tighten the five nuts of the

cutting head, mount the bottom cover and mount the weighs with the cover.