Miller XT30 Instrukcja obsługi - Strona 21

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System spawania Miller XT30. Miller XT30 40 stron. Air plasma cutting and gouging
Również dla Miller XT30: Instrukcja obsługi (44 strony)

Drukuj stronę

5-7. Connecting 120 Volt Input Power

A complete Parts List is available at www.MillerWelds.com

Installation must meet all National and

Local Codes − have only qualified

persons make this installation.

Special installation may be required

where gasoline or volatile liquids are

present − see NEC Article 511 or CEC Sec-

tion 20.

See rating label on unit and check input voltage

available at site.

The Auto-Line circuitry in this unit automati-

cally links the power source to the primary

voltage being applied, either 120 or 240

VAC.

For 120 volts AC input power, a 15 or 20 ampere

individual branch circuit protected by time-delay

fuses or circuit breaker is required.

Multi-Voltage Plug And Power Cord

Connector (NEMA Type 5−15P Plug

Shown)

For multi−voltage plug connections, see Section

5-6.

Receptacle − NEMA Type 5−15R

(Customer Supplied)

Input6 2011−03 Ref. 253 558-A

OM-253 555 Page 17