Miller Digital Performance Series Instrukcja obsługi - Strona 19
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria motocyklowe Miller Digital Performance Series. Miller Digital Performance Series 32 stron. Auto-darkening helmets
Również dla Miller Digital Performance Series: Podręcznik (32 strony), Podręcznik (28 strony)
Drukuj stronę
6-3.
Replacing The Lens Covers On Digital Elite Standard Helmets
1-1. Replacing The Lens Covers On Digital Elite Standard Helmets
Never use the auto-darkening lens
without the inside and outside lens
covers properly installed. Welding
spatter will damage the auto-darken-
ing lens and void the warranty.
1 Front Lens Gasket
!
Never use the auto-
2 Outside Lens Cover
darkening lens with-
3 Lens Assembly Gasket
out the inside and
outside lens covers
4 Lens Assembly
properly
5 Inside Lens Cover
Welding spatter will
6 Lens Frame
damage the auto-dark-
ening lens and void the
Remove the lens assembly to remove either
warranty.
lens cover.
1
Front Lens Gasket
To remove the lens assembly, push down on
the helmet bottom retaining arms and push
2
Outside Lens Cover
the retaining clips toward the outside of the
3
Lens Assembly Gasket
helmet. Lift up on the assembly and pull free
of the helmet.
4
Lens Assembly
5
Inside Lens Cover
6
Lens Frame
Remove the lens assembly
Ref. 805012
to remove either lens cover.
To remove the lens assem-
bly, push down on the helmet
installed.
bottom retaining arms and
push the retaining clips to-
ward the outside of the
helmet. Lift up on the assem-
bly and pull free of the
helmet.
Outside Lens Cover
Remove the outside lens
cover by pushing cover into
the helmet. Remove the rub-
ber lens gasket and install on
the new lens cover. Reinstall
the lens assembly.
2
1
Outside Lens Cover
Remove the outside lens cover by pushing
cover into the helmet. Remove the rubber
lens gasket and install on the new lens cov-
er. Reinstall the lens assembly.
�
Be sure wide edge of gasket faces hel-
met shell.
�
Be sure the flat side of lens cover gas-
ket faces the helmet shell.
Inside Lens Cover
To replace the inside lens cover, remove the
lens assembly from the lens frame by push-
ing up on the top two retaining tabs while
gently pushing the lens free.
Remove the lens cover by sliding it out of ei-
ther side. Replace with the new cover lens
and reinstall the assembly in the helmet.
4
3
Be sure wide edge of
gasket
faces helmet
shell.
Be sure the flat side of
lens cover gasket faces
the helmet shell.
Inside Lens Cover
To replace the inside lens
cover, remove the lens as-
sembly from the lens frame
by pushing up on the top two
retaining tabs while gently
pushing the lens free.
Remove the lens cover by
sliding it out of either side.
Replace with the new cover
lens and reinstall the assem-
bly in the helmet.
OM-256476 Page 17
OM-256476 Page 1
6
5