AQUAPHOR RO-70S Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Systemy filtracji wody AQUAPHOR RO-70S. AQUAPHOR RO-70S 13 stron. Drinking water machine
5. INSTALLING RO-70S
ATTENTION! Installation of RO-70S must be performed by specialists authorized to carry out this
type of work.
Handset JG 3/8
Handset JG 1/4
Figure 2
Determine a convenient location of the faucet for clean
water and the RO-70S. Pay attention to the fact that the
supply tubes must pass freely, without loops or kinks (fig. 2).
The RO-70S must be installed on a flat, sturdy surface
(installation on an uneven surface may result in vibration or
noise).
RO-70S should be distanced or isolated from heat
sources (cookers, boilers, hot water pipes, dishwashers or
washing machines, etc.).
Installation of the connection node* (fig. 3)
• Shut off the cold water.
• Open the kitchen faucet to relieve pressure in the water
supply.
• Connect the cold water supply water connection.
• Connect the red JG tube. For this, pull out from under the
plastic bushing stopper-clip, insert the pre-soaked end of
the tube into the sleeve of the union up to the stop to a
depth of approximately 20 mm and reinstall the clip.
• Check the strength of the tube fastening:
* The manufacturer reserves the right to use the connection points and faucet of a similar design. If necessary, contact the
after-sales service.
4
Handset JG 1/4
with pressed
metal hub
Fig. 5
Direction of water flow
The input tap
is set to the
position Closed
Locking clip
Figure 3
Fig. 4
Cold Water
Pipe water
supply
Fig. 3
Sealing pad
AQUAPHOR RO-70S | Owner's manual
Connection
node