Diamond CSP/4 Podręcznik - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik dla Komercyjny sprzęt spożywczy Diamond CSP/4. Diamond CSP/4 8 stron.

3.2 - PACKAGE CHECK UP ON RECEIPT

If no external damage is evident on the package upon its arrival, open it and check

that all the components are inside (see FIG. n°3). If the package has suffered

rough handling, bumps or crashes, the carrier must be informed about any

damage; moreover a detailed report on the extent of the damage caused to the

machine must be filled within three days from the delivery date shown in the

shipping documents. Do not overturn the package!! When the package is

transported, make sure the box is lifted by the 4 corners (parallel to the ground).

3.3 - PACKAGING DISPOSAL

The components of the packaging (cardboard, pallet, plastic straps and

polyurethane) are urban solid waste; therefore they can be easily disposed.

If the machine has to be installed in countries where specific regulations are in

force, packaging must be disposed in compliance with them.

CHAP. 4 - INSTALLATION

4.1 - SETTING UP OF THE MACHINE

The machine must be installed on a working table suitable for its overall

dimensions shown in Tab. 1 (in accordance with the model), therefore it must be

adequately large, well levelled, dry, smooth, resistant, stable.

Moreover the machine must be installed in a room with max. 75% not saline

humidity at a temperature between +5°C and +35°C; that is to say in a place that

does not provoke the machine failure.

4.2 - ELECTRICAL CONNECTIONS

Tha appliance is equipped with a power supply cord which section 3x1.5mm²,

length 1.5m with a "SUKO" plug.

Connect the appliance to 230 Volt 50 Hz, by interposing a differential-

magnetothermic switch of 10A, ∆ I = 0.03A. Check that the earthing is fully

operational. Moreover check that the features on the rating plate - serial number

(see FIG. n°4) correspond to the features shown in the consignment and delivery

note.

FIG. n°4 - Rating plate - serial number

4.3 - ELECTRIC DIAGRAMS

4.3.1 - Single-phase electric diagram

FIG. n°5 - Single-phase electric diagram.

4.3.2 - Single-phase electric diagram. CUTTER with speed dial knob.

FIG. n°6 - Single-phase electric diagram. CUTTER with speed dial knob.

4.4 - OPERATION CHECKS

Check the proper functioning of the machine according as follows:

1 press the start button "I" and the stop button "0";

2 check whether the machine stops after the lid has been removed;

3 in case of a CUTTER equipped with a speed dial knob, check whether the

number of rotations increases by adjusting the knob clockwise.

CHAP. 5 - USE OF THE MACHINE

5.1 - CONTROLS

Controls are placed on the CUTTER body as shown in the picture below.

NOTE: The speed dial knob (1) is installed only in the vv model.