Aquasana AQ-4100NSH Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Systemy filtracji wody Aquasana AQ-4100NSH. Aquasana AQ-4100NSH 5 stron. Shower filter
Również dla Aquasana AQ-4100NSH: Instrukcja obsługi (5 strony)

Drukuj stronę

INSTALLATION STEPS

Important Safeguards

• Do not install this filter where the line pressure may exceed 80 psi. The

operating pressure range for this filter is between 30 psi - 80 psi.

• Do not overtighten the chrome inlet collar. This may cause the washer to

compress, resulting in leaking around the connector. If this occurs, unscrew

the chrome inlet collar from pipe, reinstall the washer, and reconnect the

shower pipe.

• This system is not intended to be a drinking filter system.

• Only shower heads up to 4.5" in diameter will fit model AQ-4100NSH.

• This system and installation must comply with applicable state and local

regulations.

Installation Steps

Unpack and Prepare For Installation

1. Remove black plastic caps from Shower Filter Cartridge.

2. Ensure white rubber washer is in place in the chrome inlet collar.

3. Remove your existing shower head from shower pipe.

Attach Shower Filter Cartridge

1. Wrap Plumber's Tape around threads of

shower pipe.

2. Attach chrome swivel collar to shower

pipe. Turn clockwise by hand to

tighten. Using pliers, turn chrome

swivel one additional quarter turn.

Do not overtighten.

NOTE: If there is pre-existing

plumber's tape, remove old

tape before applying new.

Flush Filter

• Turn on COLD water for 2 minutes to

flush the filter. Shower water should run

clear. Then adjust to normal temperature

(mixture of hot and cold water). Turn

water off and on 3 to 4 times or until the

initial surge of water is clear.

Attach Shower Head

For model AQ-4100

• Attach Massaging Shower Head

to the Shower Filter Cartridge.

Hand tighten.

NOTE: Please see Step 3 to flush filter.

For models AQ-4105 or AQ-4105CHR

1. Attach Cradle Assembly: Attach Cradle

Assembly to Shower Filter Cartridge.

Hand tighten only.

2. Assemble Hose and Wand: Insert one

washer into hose nut and hand tighten

onto bracket. Insert second washer into

hose nut and screw onto Shower Wand.

3. Place Shower Wand into Cradle

Assembly and adjust to desired

position. Hand tighten swivel nut to

connect Hose to Cradle Assembly.

NOTE: Please see Step 3 to flush filter.

INSTALLATION STEPS