Aquasana AQ-4100NSH Руководство пользователя - Страница 3
Просмотреть онлайн или скачать pdf Руководство пользователя для Системы фильтрации воды Aquasana AQ-4100NSH. Aquasana AQ-4100NSH 5 страниц. Shower filter
Также для Aquasana AQ-4100NSH: Руководство пользователя (5 страниц)
Печатать страницу
2
INSTALLATION STEPS
2
Important Safeguards
• Do not install this filter where the line pressure may exceed 80 psi. The
operating pressure range for this filter is between 30 psi - 80 psi.
• Do not overtighten the chrome inlet collar. This may cause the washer to
compress, resulting in leaking around the connector. If this occurs, unscrew
the chrome inlet collar from pipe, reinstall the washer, and reconnect the
shower pipe.
• This system is not intended to be a drinking filter system.
• Only shower heads up to 4.5" in diameter will fit model AQ-4100NSH.
• This system and installation must comply with applicable state and local
regulations.
Installation Steps
Unpack and Prepare For Installation
1
1. Remove black plastic caps from Shower Filter Cartridge.
2. Ensure white rubber washer is in place in the chrome inlet collar.
3. Remove your existing shower head from shower pipe.
Attach Shower Filter Cartridge
2
1. Wrap Plumber's Tape around threads of
shower pipe.
2. Attach chrome swivel collar to shower
pipe. Turn clockwise by hand to
tighten. Using pliers, turn chrome
swivel one additional quarter turn.
Do not overtighten.
NOTE: If there is pre-existing
plumber's tape, remove old
tape before applying new.
3
4
1
2
Flush Filter
• Turn on COLD water for 2 minutes to
flush the filter. Shower water should run
clear. Then adjust to normal temperature
(mixture of hot and cold water). Turn
water off and on 3 to 4 times or until the
initial surge of water is clear.
Attach Shower Head
For model AQ-4100
• Attach Massaging Shower Head
to the Shower Filter Cartridge.
Hand tighten.
NOTE: Please see Step 3 to flush filter.
For models AQ-4105 or AQ-4105CHR
1. Attach Cradle Assembly: Attach Cradle
Assembly to Shower Filter Cartridge.
Hand tighten only.
2. Assemble Hose and Wand: Insert one
washer into hose nut and hand tighten
onto bracket. Insert second washer into
hose nut and screw onto Shower Wand.
3. Place Shower Wand into Cradle
Assembly and adjust to desired
position. Hand tighten swivel nut to
connect Hose to Cradle Assembly.
NOTE: Please see Step 3 to flush filter.
INSTALLATION STEPS
3
1
3
2