AquaScape 95027 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Systemy filtracji wody AquaScape 95027. AquaScape 95027 20 stron.

Drukuj stronę

• Insert IonGen Probe cord through the IonGen Probe collar

(Ex. 8).

• Hand-tighten the IonGen Probe collar into position (Ex. 8).

• Plug the connector from

the Control Panel into

the IonGen Probe fitting

connector (Ex. 9).

Option B: Only Using

IonGen Probe Holder

• The IonGen Probe can also

be submerged in a filter by

using the IonGen Probe

Holder.

1. Position the probe holder bracket in the desired

location on check valve or plumbing (Ex. 10).

2. Pull the buckle securely fastening the probe holder in

place.

3. Trim away remaining or excess strap if necessary.

4. Position the IonGen Probe into the probe holder.

IMPORTANT: The IonGen Probe must be fully

submersed in water at all times to function

properly. Failure to provide sufficient water flow

across IonGen Probe will affect the IonGen

System's performance. See Troubleshooting for more

information.

☎

aquascapeinc.com |

CAN (866) 766-3426 |

NOTE: The IonGen System may be used for algae control

in ponds or fountains containing fish as long as the copper

concentration is carefully monitored and the concentration

is not allowed to exceed 0.25 ppm.

NOTE: If the total alkalinity of the water is less than 100

ppm, you'll need to increase the level of alkalinity. DO NOT

operate the IonGen System on water features with fish if

the alkalinity levels are below 100 ppm.

Ex. 7

NOTE: If the total alkalinity of the water is above 250 ppm

you will need to decrease the level of alkalinity. If alkalinity

is more than 250 ppm it can be typically reduced by

conducting a partial water change. Check to make sure

your tap water is within the target water parameters.

NOTE: Alkalinity (not hardness) can be determined using

the KH/Alkalinity Test Kit (part #96019). Alkalinity levels

outside of the recommended parameters will significantly

reduce and possibly eliminate the effectiveness of the

IonGen System to control the algae. See Targeted Water

Parameters section for more information.

Ex. 8

STEP 3

SETTING THE IONGEN

• Turn on the pump and plug in the IonGen System (Ex. 11).

• Adjusting the IonGen System's Level - Depress the "+" or

"-" button for 3 seconds to enter the setting mode. Once

in the setting mode the ionization level can be adjusted

(Ex. 12). The setting mode will exit automatically.

Ex. 9

• If operating the IonGen System on a new water feature

or a water feature with good water quality and little to no

algae, set the IonGen System to level 1 or 2. Follow the

next step if algae growth begins to increase.

Ex. 10

on the low level will make sure the copper levels don't

become too elevated, and also prolong the life of the

IonGen Probe.

☎

US (866) 877-6637

SYSTEM'S LEVEL

™

Ex. 11

IMPORTANT: Operate the IonGen System at a

low level and only raise the ionization level if the

algae attached to rocks and gravel becomes

excessive. Maintaining the IonGen System

Ex. 12