AquaScape 95027 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Systemy filtracji wody AquaScape 95027. AquaScape 95027 20 stron.

Drukuj stronę

Installation

IMPORTANT: Before installing the IonGen

System in existing water features, it is

recommended to thoroughly clean the pond of

as much algae and debris as possible. This will maximize

the ions' effectiveness and speed to achieve desired

results. The more algae and debris in the water feature,

the longer it will take the Aquascape IonGen System to

provide noticeable results.

STEP 1

MOUNT THE CONTROL

PANEL

• Mount the IonGen System

Control Panel in the desired

location (Ex. 1); making sure

the power cord reaches

the GFI outlet and the

IonGen Probe cord reaches

the desired location of

the IonGen Probe. A 25'

Extension Cable with Quick-Connects (sold separately) is

available, if needed. The IonGen System Control Panel is

weather-resistant, but in order to maximize the lifespan of

your unit, we suggest mounting the panel above ground in

a location protected from the elements.

STEP 2

INSTALL THE FLOW CHAMBER

• The Flow Chamber for the IonGen System can be

located in several areas within the water feature. The

Flow Chamber is most effective when plumbed directly

into the water feature's recirculating system. The IonGen

Probe can also be installed without the Flow Chamber by

submerging it in a filter, such as in a skimmer or Pondless

Waterfall Vault. Follow the step-by-step installation

instructions for the method you select.

Option A: Install into Recirculating System

• Cut and insert the Flow Chamber into the water feature's

recirculating system (Ex. 2). The Flow Chamber should

be positioned after the water feature's pump, and in a

region of the plumbing line that drains by gravity. This

enables you to easily service the IonGen Probe and allows

for overwintering the Flow Chamber and fittings. It is

recommended to use a pre-filter, such as a skimmer, prior

to the Flow Chamber, in order to remove solids and debris

that may interfere with the IonGen Probe. A small valve

box may be used for easy access during maintenance

(Ex. 3).

• Select the fittings needed for the application. The PVC

slip fitting is designed to be used with Schd 40 PVC pipe

rigid or flex and PVC glue. The multi-hose adapter fitting is

designed to be used with kink-free pipe and hose clamps.

Refer to page 3 for adapters and fittings.

• Hand thread the selected

fitting into the Flow Chamber

(Ex. 4).

NOTE: Do not use tools to

Ex. 1

install the fittings into the

Flow Chamber. Fittings need

to be hand-tight only.

• If using a diameter pipe

larger than the smaller hose tails, cut off the hose tails

not being used with a hack saw in order to maximize the

water flow through the plumbing.

• When using the Barbed

Multi-Hose Fitting, use a

metal hose clamp to secure

pipe to fitting (Ex. 5).

• When using PVC, glue pipe

into Slip Fitting using PVC

glue (not included). Follow

the glue manufacturer's

directions for proper

plumbing steps (Ex. 6).

• Install the IonGen Probe into the top of Flow Chamber

(Ex. 7).

☎

US (866) 877-6637 |

Ex. 2

CAN (866) 766-3426 | aquascapeinc.com

Ex. 3

Ex. 4

Ex. 5

Ex. 6