Aquascape Pro Pond Air PRO Instrukcje i konserwacja - Strona 4

Przeglądaj online lub pobierz pdf Instrukcje i konserwacja dla Sprzęt do trawników i ogrodów Aquascape Pro Pond Air PRO. Aquascape Pro Pond Air PRO 8 stron.

Drukuj stronę

inStallatiOn

• Carefully unpack the

Aquascape pond Air

pro system and select

location for the pond Air

pro pump. DO NOt

SUBmERGE tHE AIR

PUmP IN WAtER!

NOtE: Even though a check valve is included, we recommend

placing the pump in a location above the pond's water level,

whenever possible, to prevent water from

ever entering the pump.

• Thread the barbed fitting into the

discharge of the pump.

• Attach the end of air

tubing with the pre-

installed check valve

to the front of the air

pump. the check valve

is designed to prevent

water from siphoning

back through the tubing

and entering into the

compressor. failure

to install the check

valve may result in

the compressor being

permanently damaged,

voiding the warranty.

• Attach the Aeration Disc

to the opposite end of the

air tubing.

• Position the Aeration Disc in the bottom of the pond during

summer or on a pond shelf during winter.

tIP - Rocks or gravel can be

used to hide the airline

tubing and to prevent it

from floating.

• Connect the pump to an

outlet that is protected

by a ground fault circuit

interrupter (gfCi)

OPeratiOn and MaintenanCe

Winter application: the

pond Air pro can be used

during the winter months,

where bubbles and water

movement created at the

surface help to maintain

a small opening in the

ice for oxygenation. Do

Not place the Aeration

Disc on the bottom of the

pond during the winter, as

it may disrupt the natural

thermocline found in the

deeper portions of the

pond where the fish are

overwintering. instead,

place the Aeration Disc

about 1 to 1 ½ feet below the surface of the water.

if you choose not to operate your pond Air pro during the

winter, we recommend covering the pump or storing it in a

frost-free location.

maintenance: the Air

inlet Sponge filter should

be checked annually or

if the pump ever makes

CheCk ValVe

any abnormal noises.

if operating the unit in

dusty conditions, you will

need to check it more

frequently. the pump is

easily checked by gently

popping off the top plastic

pump cover.

the Sponge filter and lid can be rinsed in clean water and

thoroughly dried before replacing. replacement Sponge filters

and lids can be purchased from your local Aquascape Dealer.

trOUbleShOOting

• Reduced or No Air Flow

– Make sure check valve is orientated in the proper direction

– Make sure airline tubing is not kinked or restricted

– Check the Air inlet Sponge filter for clogging,

and clean if needed.

– replace Aeration Disc

– Do not exceed maximum depth rating of 8' for the

placement of Aeration Disc.

tIP - Should a kinked tube or dirty Aeration Disc significantly

block air flow, shut down the pump immediately to

prevent overheating.

• Pump Not Working

– the ground-fault circuit-interrupter (gfCi) may have tripped

– the pump is not receiving the correct voltage

☎

US 1-866-877-6637 |

☎

CAN 1-866-766-3426 | www.aquascapeinc.com