Panasonic WV-NP502 Instrukcja instalacji - Strona 18
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Kamera Panasonic WV-NP502. Panasonic WV-NP502 32 stron. Ip video cameras
Również dla Panasonic WV-NP502: Tabela porównawcza (6 strony), Uwaga dotycząca integracji (8 strony)
Drukuj stronę
Installation
Connect the safety wire
The following is an example of safety wire connection. A safety wire kit shall be procured in accor-
dance with the mounting face of the camera.
Refer also to the instructions for the safety wire kit at mounting the safety wire.
Important:
• Be sure to install the safety wire. Ask your dealer for installation.
For mounting on ceiling
<Required camera mount bracket and safety wire
kit>
• Camera mounting plate: WV-7010A
• Safety wire kit: WV-Q141
z
Remove the tripod mount base on the top of
the camera.
x
Align the tripod mount base with the safety wire
plate for ceiling (accessory) and attach them to
the camera with the mounting screws.
Important:
• Use the detached mounting screws to attach the tripod mount base. When using different
length screws, it may damage the camera or cause the camera to fall.
(Recommended tightening torque: 0.39 N·m)
c
Engage the safety wires (2 pieces) with the wire engaging holes (front and rear) respectively.
Wire engaging hole
q Pass the ring part of the safety wire
through the wire engaging hole.
Important:
• Use caution to prevent the safety wire from entering into the exhaust port.
18
Safety wire
Mounting screws
Tripod mount
base
Safety wire plate
for ceiling
(accessory)
Wire engaging
hole (front)
Connection hook
w Pass the connection hook through the ring
part of the safety wire.
Wire engaging
hole (rear)
Exhaust port