AquaSource T801 0274044 Podręcznik
Przeglądaj online lub pobierz pdf Podręcznik dla Toalety AquaSource T801 0274044. AquaSource T801 0274044 19 stron. High-efficiency dual-flush toilet
Drukuj stronę
DO YOU HAVE?
Supply Line
Adjustable
Wrench
Putty Knife
Flathead
Screwdriver
Carpenter's
Level
Hacksaw
Safety
Goggles
NOTE: Items not included.
ATTACH YOUR RECEIPT HERE
Questions, problems, missing parts? Before returning to your retailer, call our customer service
department at 1-866-417-7564, 8 a.m. - 8 p.m., EST, Monday - Friday.
AB16338
AquaSource
is a registered trademark of LF, LLC.
®
All Rights Reserved.
HIGH-EFFICIENCY DUAL-FLUSH TOILET
ITEM #0274044
MODEL #T801
Estimated Installation: 50 Minutes
ARE YOU READY?
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
If replacing an existing toilet, follow these general guidelines. (Not all
toilets and connections are the same. Therefore, these guidelines may
or may not apply.)
Remove Old Toilet
1. Turn off water supply and flush tank completely. Use a towel to
dry remaining water from tank and bowl.
2. Disconnect and remove old water supply line.
3. Remove tank from bowl by removing old tank-to-bowl hardware.
4. Remove bowl from floor by removing bolt caps and floor bolt nuts.
5. Remove floor bolts from toilet flange and clean old wax, putty and
sealant from base area. (Temporarily plug floor flange with a towel
or cover to block sewer gases from escaping.)
WARNING: Do not use in-tank cleaners in your toilet.
Products containing chlorine (calcium hypochlorite) can
seriously damage fittings in the tank. This damage can cause
leakage and property damage.
CAUTION: Do not lift or rock the bowl after placement. If
you break watertight seal, you must install a new wax seal.
Be sure the water supply valve is shut off before installation.
NOTE: Mounting surface must be clean and level before
new toilet is installed.
1
Français p. 7
Español p. 13