AquaSource T801 0274044 Podręcznik - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik dla Toalety AquaSource T801 0274044. AquaSource T801 0274044 19 stron. High-efficiency dual-flush toilet

8. Install Seat

Turn the seat (C) upside down and place the hinge gaskets

(KK) into place as shown. Then, turn the seat (C) over. Place

seat (C) on bowl (A), aligning the holes of the toilet seat (C)

with the holes in the back of the bowl (A). Thread the adjustable

washers (OO) onto the nylon screws (FF), and insert the nylon

screws (FF) through the holes and secure them with the rubber

washers (LL), white plastic washers (PP) and nylon wing nuts

(QQ) from the bottom of the toilet. Adjust the toilet seat (C) to fit

over the bowl (A) before fully tightening the nylon screws (FF).

Place the decorative covers (RR) onto the hinge hole.

9. Install Flush Button

Position flush button (E) on top of the tank lid (D) so the small

button with the blue rod (half flush) will align with the green button

on top of the flush valve preassemble to tank (B) and the larger

button with the white rod will align with the white button (E) in tank

lid (D) by hand tightening lock nut (NN).

The flush button (E) may have been assembled at the factory.

NOTE: Make sure the tip on the bottom of the push rods leading from

the flush buttons lightly touch the top of the levers on the flush valve. To

increase the rod length, turn the rod locknut counterclockwise to loosen,

then rotate the push rod counterclockwise to increase exposed length.

When desired length is achieved, turn the rod locknut clockwise while holding

the push rods until it is tightened. To shorten the rod length, turn the rod locknut

counterclockwise to loosen, then rotate the push rod clockwise decrease exposed length. When

desired length is achieved, turn the rod locknut clockwise while holding the push rods until its tightened.

CAUTION: Do not use in-tank bowl cleaners as they can contain aggressive chemicals that attack the tank

components and will void the warranty.

• After installation, flush several times and check for leaks.

• The small button is for a light flush that takes away only liquids. It uses only 1.1 gallons of water.

The larger button is for a complete flushing action that takes away solids and liquids.

This flush uses 1.6 gallons of water and is a standard flushing action that

disposes of waste and cleans the basin.

• Always test cleaners on a small, inconspicuous area first.

• Always use soft cloths or sponges to clean the surface. Using abrasive materials may damage the surface of the toilet.

• Flush valves are set at the factory and should not need adjustment.

• Always rinse cleaning solutions from the surface immediately after cleaning. Do not let chemicals remain on the toilet

surface for extended periods of time.

INSTALLATION INSTRUCTIONS

CARE AND MAINTENANCE

(3 inch)

Solid