Panasonic AW-HS50 Series Podręcznik - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik dla Aparat cyfrowy Panasonic AW-HS50 Series. Panasonic AW-HS50 Series 4 stron. Combining pinp
Również dla Panasonic AW-HS50 Series: Podręcznik (20 strony), Broszura i specyfikacje (4 strony), Podręcznik (2 strony), Skrócona instrukcja obsługi (4 strony), Skrócona instrukcja obsługi (6 strony)

2．AW-HS50 Audio Settings

* In order that the audio superimposed on an SDI input signal is can pass through, the setting change below is required.

① Hold down OSD ON button – (Fig.5-A) for 2 seconds to open the menu. (Hold it down again for 2 seconds to

close the menu.)

② Use OSD/TIME dial – (Fig.5-B) to set the settings for individual output signals you want to allow to pass through.

Menu: ［14］SYSTEM Menu – (Figure 6) ＞［Set the settings for output signals individually. – (Figure 7)］

<Note>

・You cannot fix and continue to output the audio of a specific input. When the video is switched, the audio is

also switched together.

・Even if an SD signal is input in DbyD or UC mode while AW-HS50's format setting is 1080/59.94i, 720/59.94p

or 1080/50i, the audio is not allowed to pass through.

(Figure 5: AW-HS50 Control Panel)

(*1) If PGM bus or others are selected for the AUX output signal, only the [On] setting of "4. AUX Anci" is not enough

for the audio to pass through.

When the following buses are selected, please change their settings in addition to "4. AUX Anci [On]".

・PGM is selected as a source. ⇒ 5．PGM Anci ［On］

・PVW is selected as a source. ⇒ 6．PVW Anci ［On］

・MV is selected as a source. ⇒ 7．MV Anci ［PGM or PVW］

* If a selected source is KEY_OUT or CLN, the audio will not pass through.

4．For allowing the audio of a source selected at AUX buss to pass through: ［On］(*1)

5．For allowing the audio of a source selected at PGM buss to pass through: ［On］

6．For allowing the audio of a source selected at PVW buss to pass through: ［On］

7．Setting for the output signal for Multi View Display

For allowing the audio of a source selected at PGM bus to pass through: ［PGM］

For allowing the audio of a source selected at PVW bus to pass through: ［PVW］

（B）

（A）

(Figure 6: AW-HS50 Menu Display Screen)

(Figure 7)

* Screen shows default settings