HP 1405-5 Instrukcja instalacji i rozpoczęcia pracy - Strona 33

Przeglądaj online lub pobierz pdf Instrukcja instalacji i rozpoczęcia pracy dla Przełącznik HP 1405-5. HP 1405-5 44 stron. 1405 switch series
Również dla HP 1405-5: Skrócona instrukcja obsługi (16 strony), Instrukcja instalacji i rozpoczęcia pracy (45 strony)

Drukuj stronę
HP 1405-5 Instrukcja instalacji i rozpoczęcia pracy
Table A-1. Cabling Specifications
Twisted-pair copper
Cabling and Technology Information
Specifications
10 Mbps Operation
100 Mbps Operation
1000 Mbps Operation
Note on 1000BASE-T Cable Requirements. The Category 5 networking
cables that work for 100BASE-TX connections should also work for
1000BASE-T, as long as all four-pairs are connected. But, for the most robust
connections, you should use cabling that complies with the Category 5e
specifications, as described in Addendum 5 to the TIA-568-A standard (ANSI/
TIA/EIA-568-A-5).
Because of the increased speed provided by 1000BASE-T (Gigabit-T), network
cable quality is more important than for either 10BASE-T or 100BASE-TX.
Cabling plants being used to carry 1000BASE-T networking must comply with
the IEEE 802.3ab standards. In particular, the cabling must pass tests for
Attenuation, Near-End Crosstalk (NEXT), and Far-End Crosstalk (FEXT).
Additionally, unlike the cables for 100BASE-TX, the 1000BASE-T cables must
pass tests for Equal-Level Far-End Crosstalk (ELFEXT) and Return Loss.
When testing your cabling, be sure to include the patch cables that connect
the switch and other end devices to the patch panels on your site. The patch
cables are frequently overlooked when testing cable and they must also
comply with the cabling standards.

Cabling and Technology Information Specifications

Category 3, 4 or 5, 100-ohm unshielded twisted-pair (UTP) or
shielded twisted-pair (STP) cable, complying with IEEE 802.3
10BASE-T specifications.
Category 5, 100-ohm UTP or STP cable, complying with IEEE 802.3u
100BASE-TX specifications.
Category 5, 100-ohm 4-pair UTP or STP cable, complying with IEEE
802.3ab 1000BASE-T specifications—Category 5e or better is
recommended. See note on 1000BASE-T Cable Requirements
below.
Specifications
A-3