HP 316095-B21 - StorageWorks Edge Switch 2/24 Uwaga dotycząca wydania - Strona 22

Przeglądaj online lub pobierz pdf Uwaga dotycząca wydania dla Przełącznik HP 316095-B21 - StorageWorks Edge Switch 2/24. HP 316095-B21 - StorageWorks Edge Switch 2/24 23 stron. Edge switch release notes
Również dla HP 316095-B21 - StorageWorks Edge Switch 2/24: Aktualizacja instrukcji (9 strony), Podręcznik (41 strony), Podręcznik (40 strony), Uwaga dotycząca wydania (32 strony), Uwaga dotycząca wydania (27 strony), Podręcznik (26 strony), Uwaga dotycząca wydania (27 strony), Uwaga dotycząca wydania (25 strony), Instrukcja instalacji (24 strony), Uwaga dotycząca wydania (23 strony), Uwaga dotycząca wydania (22 strony), Uwaga dotycząca wydania (23 strony), Uwaga dotycząca wydania (19 strony), Uwaga dotycząca wydania (19 strony), Uwaga dotycząca wydania (18 strony), Instrukcja obsługi (17 strony), Uwaga dotycząca wydania (17 strony), Instrukcje aktualizacji (16 strony), Instrukcja obsługi (16 strony), Instrukcja instalacji (16 strony), Uwaga dotycząca wydania (16 strony), Uwaga dotycząca wydania (17 strony), Uwaga dotycząca wydania (17 strony), Uwaga dotycząca wydania (11 strony)

About this document

Show Route port numbers are not always displayed

When the Show Route feature is enabled, the In Port # and Out Port #

information is not available on a Loop Device.

Wrong number of devices is displayed in the Create View dialog box

In the Create View dialog box, the number of devices in the fabric is displayed

incorrectly. Both offline and online devices are included in the count. Only online

devices should be counted.

Reporting function in Event Management may not be accurate

In some cases the Reporting function does not give accurate information about an

active SAN and HP strongly advises that you verify information after generating a

report. The Reporting function primarily has issues with the Fabric Ports Report,

where some ports are not listed or duplicate ports are listed.

HP-UX parameters may need to be changed before you run the HAFM client

The following two HP-UX 11.0 kernel parameters are set too low for most Java

applications. Usually you will see this problem as a java.lang.OutOf

MemoryError: unable to create new native thread error. To

resolve the issue, edit the following parameter limits:

Client HAFM Login dialog box is not displayed after logging out

In some cases, when the client has logged out, the Log In dialog box is not

displayed. If you get inconsistent behavior or an error message, restart the client.

SAN data is not affected when you restart the client.

max_thread_proc—The maximum number of threads allowed in each

process. The minimum value (and default) is 64, which is often too low for

most Java applications. Set the value of the max_thread_proc higher than

the expected maximum number of simultaneously active threads. The

maximum value is the value of nkthread.

nkthread—The total number of kernel threads available in the system. This

parameter is similar to the nproc tunable except that it defines the limit for

the total number of kernel threads able to run simultaneously in the system.

The value must be greater than nproc. The default is approximately twice

that of nproc. The maximum is 30000. The suggested value of nkthread

is 2*max_thread_proc. If you have many Java processes running and

each running process uses many threads, you should increase this value.

HP StorageWorks HA-Fabric Manager release notes