HP StorageWorks 7110 - Virtual Array Korzystanie z instrukcji

Przeglądaj online lub pobierz pdf Korzystanie z instrukcji dla Przełącznik HP StorageWorks 7110 - Virtual Array. HP StorageWorks 7110 - Virtual Array 34 stron. Private loop (hubs/direct connect)
Również dla HP StorageWorks 7110 - Virtual Array: Instrukcje aktualizacji (12 strony), Instrukcje (4 strony), Podręcznik (4 strony), Podręcznik (4 strony), Instrukcje instalacji (2 strony), Podręcznik (2 strony), Podręcznik (1 strony), Podręcznik (1 strony)

Drukuj stronę

HP StorageWorks 7110 - Virtual Array Korzystanie z instrukcji

Using VADIAG on HP-UX

This document describes the VADIAG (Virtual Array) commands supported in the offline

diagnostic environment (ODE) for HP-UX systems.

VADIAG Command Summary

The following table lists the VADIAG commands and their brief descriptions.

Command

ARRAYINDEX

Selects the specified array for testing.

CLRLOG

Clears the logs of either the selected controller or disk.

CREATELUN

Adds a LUN to the selected array.

DELETELUN

Removes a LUN from the selected array.

DESCRIBE

Displays configuration information for the selected array.

DISPFILES

Displays the firmware images found on the ODE media.

DISPMAP

Displays the arrays connected to the specified bus.

DISPVOLSET

Displays the disk volume set serial number.

DISKINFO

Displays revision information for the selected array and disks installed in each

JBOD enclosure.

DISKSTATE

Displays the state of the disks installed in the array enclosures (including the

Map disks).

DOWNLOAD

Downloads the image file to the specified array controller, disk, or JOBOD LCC.

ENCLOSURE

Selects the JBOD enclosure connected to the selected array.

FRU

Selects the specified component either for testing or to get information from.

FORMAT

Formats either the array subsystem or a disk.

HELP

Lists either all VADIAG commands or detailed information for a specified

command.

INQUIRY

Displays SCSI Inquiry data for the selected array controller, disk, or JBOD

controller.

LCCINFO

Displays information about the JBOD LCCs connected to the array.

LOOPPAIR

Selects the controller loop pair.

RANGE

Selects a range of blocks to be tested by ROMT and WRTMT.

READLOG

Reads the logs of the specified controller or disk.

Description