HP StorageWorks 7110 - Virtual Array Использование руководства

Просмотреть онлайн или скачать pdf Использование руководства для Переключатель HP StorageWorks 7110 - Virtual Array. HP StorageWorks 7110 - Virtual Array 34 страницы. Private loop (hubs/direct connect)
Также для HP StorageWorks 7110 - Virtual Array: Инструкции по обновлению (12 страниц), Инструкции (4 страниц), Руководство (4 страниц), Руководство (4 страниц), Инструкции по установке (2 страниц), Руководство (2 страниц), Руководство (1 страниц), Руководство (1 страниц)

Печатать страницу
HP StorageWorks 7110 - Virtual Array Использование руководства
Using VADIAG on HP-UX
This document describes the VADIAG (Virtual Array) commands supported in the offline
diagnostic environment (ODE) for HP-UX systems.
VADIAG Command Summary
The following table lists the VADIAG commands and their brief descriptions.
Command
ARRAYINDEX
Selects the specified array for testing.
CLRLOG
Clears the logs of either the selected controller or disk.
CREATELUN
Adds a LUN to the selected array.
DELETELUN
Removes a LUN from the selected array.
DESCRIBE
Displays configuration information for the selected array.
DISPFILES
Displays the firmware images found on the ODE media.
DISPMAP
Displays the arrays connected to the specified bus.
DISPVOLSET
Displays the disk volume set serial number.
DISKINFO
Displays revision information for the selected array and disks installed in each
JBOD enclosure.
DISKSTATE
Displays the state of the disks installed in the array enclosures (including the
Map disks).
DOWNLOAD
Downloads the image file to the specified array controller, disk, or JOBOD LCC.
ENCLOSURE
Selects the JBOD enclosure connected to the selected array.
FRU
Selects the specified component either for testing or to get information from.
FORMAT
Formats either the array subsystem or a disk.
HELP
Lists either all VADIAG commands or detailed information for a specified
command.
INQUIRY
Displays SCSI Inquiry data for the selected array controller, disk, or JBOD
controller.
LCCINFO
Displays information about the JBOD LCCs connected to the array.
LOOPPAIR
Selects the controller loop pair.
RANGE
Selects a range of blocks to be tested by ROMT and WRTMT.
READLOG
Reads the logs of the specified controller or disk.
Description
1