Diamondback 180 Instrukcja instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe Diamondback 180. Diamondback 180 2 stron. For toyota tacoma 2005; toyota tacoma 2006; toyota tacoma 2007; toyota tacoma 2008; toyota tacoma 2009; toyota tacoma 2010; toyota tacoma 2011; toyota tacoma 2012; toyota tacoma 2013; toyota tacoma 2014; toyota tacoma 2015; toyota tacoma 2016; toyota taco
Również dla Diamondback 180: Instrukcja instalacji (2 strony), Instrukcja instalacji (2 strony), Instrukcja instalacji (2 strony)

Drukuj stronę
MOUNT THE COVER
Close the tailgate. Place the cover onto the cargo bed so that the
12
weatherstrip along the cover's rear angle is firmly compressed
against the inside edge of the tailgate.
Center the cover side to side.
13
Open the tailgate. At the rear of the bed, mark drill locations on
14
both bed walls using the mounting-bracket slots as a template.
Cheat these marks slightly
lower than the vertical center
of the slots.
ADJUST THE LOCK RODS
Use the 1/8" hex key to loosen
21
the set screws on the linkages
of the forward lock rods.
You can leave your rearward
lock rods alone. They come
pre-adjusted from the factory.
Adjust the length of the lock rods & retighten the set screws so that:
22
A. with the lock handle in the open position, the rod tips clear the
striker brackets,
B. with the handle in the closed position, the rod tips do not strike
the bulkhead, and
C. the rods point downward.
ATTACH THE GAS SPRINGS
Attach the gas springs to the ball studs.
25
To avoid premature failure of your gas springs, attach them barrel up, shaft down.
Leave the cover closed and locked for 24 hours to allow the weatherstrip
26
adhesive, which is pressure-sensitive, to fully cure.
DiamondBackCovers.com
1/8" hex key
24 hours
Adhesive cure time
Remove the cover.
15
Drill the marks using a 3/8" bit.
16
Repeat steps 5–8 to insert
17
rivet nuts into each hole.
Repeat step 12.
18
Attach the front of the cover to
19
the clamp bracket using the
cap clamps.
At rear, insert a hex bolt through a plain
20
washer, through each bracket slot, and into
each rivet nut. Tighten with a 7/16" socket.
To get the weatherstrip compression necessary for its adhesive
to cure and for the cover to keep out the weather, have a second
person press down on the rear of the cover while you're attaching
the mounting brackets.
Position the lock rods tight
23
against the underside of the
striker brackets (forward) and
T-panel gutter (rearward) so
that they draw the
panels down and
compress the
perimeter weather-
strip. Tighten the rod
guide brackets with a
7/16" socket.
To get the weatherstrip compression necessary for its adhesive to
cure and for the cover to keep out the weather, have a second
person press down on the cover while you're adjusting the lock rods.
If there isn't enough travel in the forward rod guide bracket to
position the rod so that it presses against the striker, reshape
the striker's V bend with pliers.
Double-check both panels to ensure they open, close, lock & seal
24
correctly. If at any point the weatherstrip does not touch the bed
rails, readjust the lock rods and mounting brackets as needed.
Operating the access panels is easiest when
you press down as you open or close them.
7/16" socket
MAY 2017
OCTOBER 2018