Bionaire BEF6300 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kominek wewnętrzny Bionaire BEF6300. Bionaire BEF6300 4 stron. Electric fireplace heater
Również dla Bionaire BEF6300: Instrukcja obsługi (8 strony)

Drukuj stronę

for Fan only setting

1= for continuous low heat (1kW)

2= for continuous high heat (2kW)

Press again for no mode operation.

FLAME INTENSITY

There are five flame brightness settings,

ranging from a low to high setting and then

OFF. Press flame intensity button (K) on

the control panel or remote control to select

desired intensity. Please note that this

function works on all modes and is also fully

independent.

AUTO SAFETY SHUT OFF

This heater is equipped with a technologically

advanced safety system that automatically

shuts off the current to the heater when a

potential overheat temperature is reached. The

heater can resume operation only when you

reset it and after it has cooled down.

RESET INSTRUCTIONS

If the unit shuts down:

1. Turn main unit ON/OFF Switch to position

( ) (see Fig. 2, L)

2. Unplug unit, wait 30 minutes

3. Plug in the unit

4. Turn main unit ON/OFF Switch to position

—

(

) (see Fig. 2, L)

5. Select desired mode and setting following

operating instructions.

BULB REPLACEMENT

1. Turn off and unplug the unit from the power

socket.

2. Leave the unit to stand for 5 minutes so

that the bulb can cool down.

3. Remove the front glass panel to a safe

place.

4. Empty the pebbles from the unit.

5. Unscrew the light bulb access panel (C)

using a cross head screwdriver, being

careful not to lose the screws.

6. Pull out the bulb.

7. Replace the G9 Type bulb with the same

type with a 40W max rating.

8. Screw back the light bulb access panel,

replace the pebbles and front glass and

plug the unit into the power socket for

operation.

Note: The G9 Type bulb should be readily

available from most hardware stores. If not

please contact the manufacturer for further

assistance.

CLEANING AND MAINTENANCE

• Always unplug the heater before cleaning

and allow to cool.

• To clean glass use household glass cleaner.

• Lightly run a vacuum cleaner nozzle over the

heater vent to remove any dust or dirt that

may have accumulated.

• Carefully wipe the heater with a soft, damp

cloth. Please be very cautious near the

heating elements.

• After cleaning, be sure to completely dry the

heater with a cloth or towel before switching

on.

• Store your heater in a cool, dry location.

TROUBLESHOOTING

Flame not bright enough

1. Regulate flame brightness using the flame

intensity button.

2. Check bulb is working and replace if

necessary.

Simulated fire will not illuminate

1. Check power.

2. Press the flame intensity button.

3. Check bulb and replace if necessary.

Unit making crackling/popping sound

1. This is normal; when the unit is first used or

has not been used for a while this sound is

caused by dust buildup burning away.

2. Please refer to Cleaning and Maintenance

section for prevention.

Heater will not turn off

1. Refer to operating instructions.

Heater blows cool air

1. This is normal when the unit is on the fan

only setting.

2. Press the mode control until you select the

LOW (1) or HIGH (2) heat setting.

Remote does not work

1. Check the ON/OFF switch on the main unit

is in the ON position.

2. Change batteries (See Assembly

Instructions).

3. Be sure to point remote at the main unit.

4. Be sure there are no obstructions between

remote and unit.

Not enough heat

1. This is a 2000 watt heater and is intended for

supplementary heat only.

FOR U.K. AND IRELAND ONLY

If the plug is not suitable for the socket outlets

in your home, it can be removed and replaced

by a plug of the correct type. Please refer to

"Installation of a plug" below.

Installation of a plug applicable to

U.K. and Ireland

NOTE: If the terminals in the plug are not

marked or if you are unsure or in doubt about

the installation of the plug please contact a

qualified electrician.

If a 13A 3-pin plug is fitted, it must be an ASTA

approved plug, conforming to BS1363 standard.

Replacement 13A fuses must be BSI or

ASTABS1362 approved.

This product is fitted with a 13A plug complying

to BS1363. If this plug is unsuitable or needs

to be replaced, please note the following: The

wires in the mains lead are coloured as such:

BROWN - LIVE

BLUE

- NEUTRAL

Please note that the colour of these mains wires

may not correspond with the colour markings

that identify the terminals in your plug. Please

proceed as follows:

The BROWN coloured wire must be connected

to the terminal, which is marked with the letter

"L" or is coloured RED.

The BLUE coloured wire must be connected to

the terminal, which is marked with the letter "N"

or is coloured BLACK.

DO NOT CONNECT either of these wires to the

earth terminal in the plug. The earth terminal

plug is marked with the letter "E", or with the

earth symbol

, or coloured GREEN, or

GREEN and YELLOW.

GUARANTEE

Please keep your receipt as this will be

required for any claims under this guarantee.

This appliance is guaranteed for 2 years after

your purchase as described in this document.

During this guaranteed period, if in the unlikely

event the appliance no longer functions due to

a design or manufacturing fault, please take

it back to the place of purchase, with your till

receipt and a copy of this guarantee.

The rights and benefits under this guarantee

are additional to your statutory rights, which

are not affected by this guarantee. Only

Holmes Products (Europe) Ltd. ("Holmes") has

the right to change these terms.

Holmes undertakes within the guarantee

period to repair or replace the appliance, or

any part of appliance found to be not working

properly free of charge provided that:

• you promptly notify the place of purchase

or Holmes of the problem; and

• the appliance has not been altered

in any way or subjected to damage,

misuse, abuse, repair or alteration by a

person other than a person authorised

by Holmes.

Faults that occur through, improper use,

damage, abuse, use with incorrect voltage,

acts of nature, events beyond the control of

Holmes, repair or alteration by a person other

than a person authorised by Holmes or failure

to follow instructions for use are not covered

by this guarantee. Additionally, normal wear

and tear, including, but not limited to, minor

discolouration and scratches are not covered

by this guarantee.

The rights under this guarantee shall only

apply to the original purchaser and shall not

extend to commercial or communal use.

If your appliance includes a country-specific

guarantee or warranty insert please refer to

the terms and conditions of such guarantee

or warranty in place of this guarantee or

contact your local authorized dealer for more

information.

This marking indicates that this product

should not be disposed with other household

wastes and should be disposed separately

throughout the EU. To prevent possible harm

to the environment or human

health from uncontrolled waste

disposal due to the presence of

hazardous substances within the

product, recycle it responsibly to

promote the sustainable reuse

of materials and resources. To

return your used device, please

use the return and collection systems available

to you or contact the retailer where the product

was purchased. They can take this product for

environmentally safe recycling.

Holmes Products (Europe) Limited

1 Francis Grove

London

SW19 4DT