Dickinson Radex 2 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Grzałka Dickinson Radex 2. Dickinson Radex 2 9 stron.

Installation

To make sure your unit has an adequate air supply install the Radex so there is at least 2"

(5.08cm) of airspace behind the fan.

Connect the circulating hot water to the pipes as shown. The outside dimension of the

copper tubing is a ¾" diameter (1.9cm). If using 5/8ths heater hose, ensure the clamp is

secure at the end of the hose to prevent slipping . We recommend the use of compression

fittings with a 3/4" diameter female tube to a 5/8" diameter male hose barb fitting (and

hose clamp).

Operate the heater and check all connections for leaks prior to final installation into wall

or cabinet.

After the fan wiring and water installation are complete, secure the Radex in the mounted

position with the desired mounting kit.

Fresh water cooled engines should mount the heater below the level of the radiator cap or

use an air bleeder to prevent trapped air locks. The Radex 2 has an installed manual air

bleed valve. Be sure the hoses are not kinked or restricted in any way.

REPORT ANY DEFICIENCIES OR MISSING COMPONENTS IMMEDIATELY

www.dickinsonmarine.com

Form# 7.2-63 (2)