DieHard 200.71225 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ładowarka DieHard 200.71225. DieHard 200.71225 20 stron. Microprocessor controlled, fully automatic operation battery charger with engine starter plus battery and alternator tester for 6 and 12-volt batteries
Również dla DieHard 200.71225: Instrukcja obsługi (17 strony)

Drukuj stronę

11.4

Clean and store the charger in a dry location.

NOTE: During the starting sequence listed above, the charger is set to

one of three states.

11.5

Engine Starting Notes:

•

wait for cranking

cranked before delivering 80 amps for engine start. The charger delivers

charge at a rate of up to 12 amps while waiting and will reset if the engine

is not cranked within 15 minutes. (If the charger resets, it sets itself for a

2A charge and 12V REGULAR battery.) While waiting for cranking, the

digital display shows the battery voltage (it can't be set to percent).

•

Cranking

deliver up to its maximum output (at least 80A) as required by the starting

system for up to 5 seconds or until the engine cranking stops. The digital

display shows a countdown of the remaining crank time in seconds. It

starts at 5 and counts down to 0.

•

Cool down

ute (180 second) cool down state. During this period, no settings can

be changed. The buttons are ignored. The digital display indicates the

remaining cool down time in seconds. It starts at 180 and counts down

to 0. The 80A START LED blinks once every second. During the cool

down period, no current is delivered to the battery. After 3 minutes, the

80A START LED will stop blinking and will light continuously, indicating

that another crank cycle can be started. The digital display will change

from displaying the countdown back to displaying the battery voltage. The

CHARGING LED will then be lit.

12.

OPERATINg INSTRUCTIONS

OVERVIEw:

Using this battery charger is very simple. First, connect the battery and AC

power following the precautions listed in sections 6 and 7. Then select the

appropriate BATTERY TYPE and CHARGE RATE for your battery. The

charger will then do everything automatically. This section explains a few

details.

12.1

CHARgINg:

the CHECK (red) LED will light continuously until such a battery is detect-

ed. Charging will not begin while the CHECK LED is on. When charging

begins, the CHARGING (yellow) LED will be lit.

12.2

AUTOMATIC CHARgE:

the charger is set to perform an automatic charge. When an automatic

charge is performed, the charger switches to the maintain mode (see

below) automatically after the battery is charged.

12.3

ABORTEd CHARgE:

ing will abort. When charging aborts, the charger's output is shut off and

the CHECK (red) LED and digital display will blink on and off (at opposite

times). In that state, the charger ignores all buttons. To reset after an

- The charger waits until the engine is actually being

- When cranking is detected, the charger will automatically

- After cranking, the charger enters a mandatory 3-min-

If the charger does not detect a properly connected battery,

When the 2A, 12A or 30A charge rate is selected,

If charging can't be completed normally, charg-

•